Used Dodge Durango engine computer from a salvage yard

Vehicle-specific price guide

How much is a used Dodge Durango engine computer?

Asking prices from 223 salvage yards in 32 states, broken down by model year, condition grade, and fitment variant.
SKWritten bySaurabh Kumar · Co-Founder & CTO
ASReviewed byAmbika Sharma · Co-Founder & COO
Last updatedSep 14, 2026
Strong coverage946 priced of 1,274 observed3 variantsMethodology v2.1 →

Part overview

About the Dodge Durango engine computer

What the engine computer does, common failure signs, and prices across all vehicles: used engine computer price guide →

Also known asECUECMPCMEngine Control ModuleEngine Control UnitPowertrain Control Module
Price summary

A used Dodge Durango engine computer costs $41 to $650, with a median asking price of $153. Based on 946 priced salvage yard listings across the US, compatible across 2015–2025 (11 model years), updated Sep 14, 2026. Prices exclude shipping, core charges, and installation.

Grade A (excellent)$161
Grade B (good)$141

Dodge Durango engine computer price snapshot

USD
Low
$41
Average
$173
High
$650
1,274 listings observed · 946 priced1mo ago· How we price·

Report incorrect price

Reporting price for Dodge Durango Engine Computer

Reason

Condition comparison

Price by part grade

Grade AClean / low wear$50–$650619 listings
Grade BStandard used$41–$410268 listings
Grade XUngraded$45–$59659 listings

Median by grade

Grade price comparison

Median asking price by seller-reported condition grade · $41–$650 overall range

Regional supply

Where the Dodge Durango engine computer is listed

We found priced Dodge Durango engine computer listings at 223 salvage yards across 32 states. Texas supplies the most, with 203 listings (21% of the total) from 24 yards. Location matters: yards in California ask a median $100, while Georgia yards ask $228, 128% more for the same part. Shipping usually costs less than that gap for smaller parts, so it can pay to buy out of state.

StateListingsYardsMedian ask
Texas20324$153
Florida13523$110-28%
North Carolina6918$215+41%
Georgia6714$228+49%
California6522$100-35%
Missouri4513$175+14%
Tennessee3615$185+21%
Mississippi3410$125-18%

States with at least 10 priced listings. % is versus the $153 national median.

Replacement cost

What is the Dodge Durango engine computer replacement cost?

ESTIMATE
Used part
$153
Dodge Durango median asking price
Labor
$95–$450
1–3 hours at $95–$150/hr
Estimated total
$250–$605
median used part + labor

Labor is a typical independent-shop range for engine computer replacement, not a quote for your vehicle; it does not include programming and key relearn procedure. The part price is the live median from the salvage-yard listings on this page. Full engine computer replacement cost breakdown

Sources
  1. Labor time estimates: Part Price Guide labor database

Set price alert

Alert for Dodge Durango Engine Computer

$

Current avg: $173 — we suggest $147 (15% below)

Condition grade (optional)

Fitment matters

Price by trim & variant (2025)

Electronic Control Module, (engine compartment), 3.6L45 listingsInterchange 2024–2025$150$100 – $290
Electronic Control Module, (engine compartment), 5.7L6 listingsInterchange 2024–2025$171$146 – $171
Electronic Control Module, (engine compartment), 6.2L6 listingsInterchange 2020–2023$596$495 – $650

Model-year comparison

What does a Dodge Durango engine computer cost by year?

$109$134$159$185$21020152016201720182019202020212022202320242025
Median asking price by model year · salvage yard listing data

Market analysis

How much does a used Dodge Durango engine computer cost?

Asking prices for a used Dodge Durango engine computer are unusually spread out: the top listing asks more than ten times what the cheapest does, so which unit you pick matters more than the median. Condition matters: grade-A units (lowest mileage, best condition) carry roughly a 14% premium over grade-B stock, with grade-A medians at $161.

Fitment variant moves the price more than most buyers expect. The most affordable variant we track, Electronic Control Module, (engine compartment), 3.6L, lists at a $150 median, while Electronic Control Module, (engine compartment), 6.2L commands $596, a 297% gap inside the same part category. Confirm which variant your VIN requires before comparing quotes.

Model year matters too: 2020 units carry the lowest median at $121, while 2015 tops the table at $200. Parts from 2020–2023 are interchangeable, so if the 2020 fits your vehicle, it offers the best value across 4 compatible years.

Against comparable vehicles, the Dodge Durango sits 37% above the Honda Accord ($112), 38% above the Honda Civic ($111), and 21% above the Hyundai Elantra ($126) for the same part. The “similar vehicles” cards below open each comparison guide.

Buying a used engine computer: what to check

  1. Match hardware and service numbers: Ensure hardware revision codes and circuit board part numbers match exactly, as pinouts change mid-model year.
  2. Inspect multi-pin connector headers: Check header pins for bending, green copper oxidation, or burnt circuit board traces inside the wiring sockets.
  3. Verify immobilizer programming requirements: Plan for anti-theft security relearn procedures or ECU re-flashing before the replacement computer will start the engine.
  4. Confirm donor transmission and emissions spec: Ensure the donor vehicle used the same transmission type and regional emissions package to prevent fault codes.
  5. Check aluminum casing seals: Inspect housing screws and perimeter rubber gaskets for white oxidation or breaks that indicate past water intrusion.

Keep browsing this vehicle

What other Dodge Durango parts are priced?

Price comparisons

Compare Dodge Durango engine computer prices

Compare fitments

What do similar vehicles charge for this part?

Common questions

Dodge Durango engine computer FAQ

How much is a used engine computer for a Dodge Durango?

The median asking price is $153 across 946 priced listings from 223 yards. Grade-A units, the cleanest stock, have a median of $161. 2022 is the cheapest model year we track, with a median of $121.

How much does it cost to replace a Dodge Durango engine computer?

Using a used part, a Dodge Durango engine computer replacement typically runs $250–$605 all-in: the median used engine computer for this model lists at $153, and independent-shop labor for engine computer replacement typically takes 1–3 hours at $95–$150/hr ($95–$450). The labor figure does not include programming and key relearn procedure. Labor is a national part-level estimate, not a quote for your vehicle.

Which Dodge Durango model years does this price guide cover?

This guide currently has year-level pricing for 2025, 2024, 2023, 2022, 2021, 2020, 2019, 2018, 2017, 2016, 2015. Other model years contribute to the overall range where sellers listed them without a year breakdown.

Which Dodge Durango engine computer years are interchangeable?

Salvage-yard interchange data links Dodge Durango engine computer fitments across 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2023, 2024, 2025. Searching all 11 years widens the pool of units; confirm the part number against your VIN, since trim or drivetrain can split an interchange group.

Used Dodge Durango Engine Computer Cost — From $41 to $650