Used Ford F250 engine computer from a salvage yard

Vehicle-specific price guide

How much is a used Ford F250 engine computer?

Asking prices from 748 salvage yards in 49 states, broken down by model year, condition grade, and fitment variant.
SKWritten bySaurabh Kumar · Co-Founder & CTO
ASReviewed byAmbika Sharma · Co-Founder & COO
Last updatedOct 29, 2026
Strong coverage3,396 priced of 3,647 observed4 variantsMethodology v2.1 →

Part overview

About the Ford F250 engine computer

What the engine computer does, common failure signs, and prices across all vehicles: used engine computer price guide →

Also known asECUECMPCMEngine Control ModuleEngine Control UnitPowertrain Control Module
Price summary

A used Ford F250 engine computer costs $61 to $694, with a median asking price of $250. Based on 3,396 priced salvage yard listings across the US, compatible across 2011–2025 (15 model years), updated Oct 29, 2026. Prices exclude shipping, core charges, and installation.

Grade A (excellent)$259
Grade B (good)$249
Grade C (fair)$175

Ford F250 engine computer price snapshot

USD
Low
$61
Average
$259
High
$694
3,647 listings observed · 3,396 pricedUpdated 7h ago· How we price·

Report incorrect price

Reporting price for Ford F250 Engine Computer

Reason

Condition comparison

Price by part grade

Grade AClean / low wear$61–$6942,147 listings
Grade BStandard used$61–$6941,111 listings
Grade CVisible wear$74–$40095 listings
Grade XUngraded$75–$59043 listings

Median by grade

Grade price comparison

Median asking price by seller-reported condition grade · $61–$694 overall range

Regional supply

Where the Ford F250 engine computer is listed

We found priced Ford F250 engine computer listings at 748 salvage yards across 49 states. Missouri supplies the most, with 1,287 listings (10% of the total) from 25 yards. Location matters: yards in Michigan ask a median $231, while Texas yards ask $319, 38% more for the same part. Shipping usually costs less than that gap for smaller parts, so it can pay to buy out of state.

StateListingsYardsMedian ask
Missouri1,28725$245-2%
Michigan1,15252$231-8%
Texas1,11449$319+28%
Indiana1,03825$314+26%
North Carolina93928$266+6%
Illinois69926$243-3%
Georgia59921$289+16%
Wisconsin48824$250

States with at least 10 priced listings. % is versus the $250 national median.

Replacement cost

What is the Ford F250 engine computer replacement cost?

ESTIMATE
Used part
$250
Ford F250 median asking price
Labor
$95–$450
1–3 hours at $95–$150/hr
Estimated total
$345–$700
median used part + labor

Labor is a typical independent-shop range for engine computer replacement, not a quote for your vehicle; it does not include programming and key relearn procedure. The part price is the live median from the salvage-yard listings on this page. Full engine computer replacement cost breakdown

Sources
  1. Labor time estimates: Part Price Guide labor database

Set price alert

Alert for Ford F250 Engine Computer

$

Current avg: $259 — we suggest $220 (15% below)

Condition grade (optional)

Fitment matters

Price by trim & variant (2025)

Electronic Control Module, 6.7L50 listings$431$225 – $694
Electronic Control Module, 6.8L50 listingsInterchange 2024–2025$348$183 – $454
Electronic Control Module, 7.3L50 listingsInterchange 2024–2025$348$183 – $454
Diesel Control, (glow plug control)47 listingsInterchange 2023–2025$345$125 – $532

Model-year comparison

What does a Ford F250 engine computer cost by year?

$171$220$269$318$36820152016201820192020202220232025
Median asking price by model year · salvage yard listing data

Market analysis

How much does a used Ford F250 engine computer cost?

Asking prices for a used Ford F250 engine computer are unusually spread out: the top listing asks more than ten times what the cheapest does, so which unit you pick matters more than the median. Condition matters: grade-A units (lowest mileage, best condition) carry roughly a 48% premium over grade-C stock, with grade-A medians at $259.

Fitment variant moves the price more than most buyers expect. The most affordable variant we track, Diesel Control, (glow plug control), lists at a $345 median, while Electronic Control Module, 6.7L commands $431, a 25% gap inside the same part category. Confirm which variant your VIN requires before comparing quotes.

Model year matters too: 2018 units carry the lowest median at $190, while 2025 tops the table at $350. Parts from 2015–2022 are interchangeable, so if the 2018 fits your vehicle, it offers the best value across 8 compatible years.

Against comparable vehicles, the Ford F250 sits 123% above the Honda Accord ($112), 125% above the Honda Civic ($111), and 98% above the Hyundai Elantra ($126) for the same part. The “similar vehicles” cards below open each comparison guide.

Buying a used engine computer: what to check

  1. Match hardware and service numbers: Ensure hardware revision codes and circuit board part numbers match exactly, as pinouts change mid-model year.
  2. Inspect multi-pin connector headers: Check header pins for bending, green copper oxidation, or burnt circuit board traces inside the wiring sockets.
  3. Verify immobilizer programming requirements: Plan for anti-theft security relearn procedures or ECU re-flashing before the replacement computer will start the engine.
  4. Confirm donor transmission and emissions spec: Ensure the donor vehicle used the same transmission type and regional emissions package to prevent fault codes.
  5. Check aluminum casing seals: Inspect housing screws and perimeter rubber gaskets for white oxidation or breaks that indicate past water intrusion.

Keep browsing this vehicle

What other Ford F250 parts are priced?

Price comparisons

Compare Ford F250 engine computer prices

Compare fitments

What do similar vehicles charge for this part?

Common questions

Ford F250 engine computer FAQ

How much is a used engine computer for a Ford F250?

The median asking price is $250 across 3,396 priced listings from 748 yards. Grade-A units, the cleanest stock, have a median of $259. 2019 is the cheapest model year we track, with a median of $190.

How much does it cost to replace a Ford F250 engine computer?

Using a used part, a Ford F250 engine computer replacement typically runs $345–$700 all-in: the median used engine computer for this model lists at $250, and independent-shop labor for engine computer replacement typically takes 1–3 hours at $95–$150/hr ($95–$450). The labor figure does not include programming and key relearn procedure. Labor is a national part-level estimate, not a quote for your vehicle.

Which Ford F250 model years does this price guide cover?

This guide currently has year-level pricing for 2025, 2023, 2022, 2020, 2019, 2018, 2016, 2015. Other model years contribute to the overall range where sellers listed them without a year breakdown.

Which Ford F250 engine computer years are interchangeable?

Salvage-yard interchange data links Ford F250 engine computer fitments across 2011, 2012, 2013, 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2023, 2024, 2025. Searching all 15 years widens the pool of units; confirm the part number against your VIN, since trim or drivetrain can split an interchange group.

Used Ford F250 Engine Computer Cost — From $61 to $694