Used Nissan Frontier engine computer from a salvage yard

Vehicle-specific price guide

How much is a used Nissan Frontier engine computer?

Asking prices from 511 salvage yards in 45 states, broken down by model year, condition grade, and fitment variant.
SKWritten bySaurabh Kumar · Co-Founder & CTO
ASReviewed byAmbika Sharma · Co-Founder & COO
Last updatedOct 22, 2026
Strong coverage854 priced of 991 observed2 variantsMethodology v2.1 →

Part overview

About the Nissan Frontier engine computer

What the engine computer does, common failure signs, and prices across all vehicles: used engine computer price guide →

Also known asECUECMPCMEngine Control ModuleEngine Control UnitPowertrain Control Module
Price summary

A used Nissan Frontier engine computer costs $35 to $550, with a median asking price of $145. Based on 854 priced salvage yard listings across the US, compatible across 2014–2025 (12 model years), updated Oct 22, 2026. Prices exclude shipping, core charges, and installation.

Grade A (excellent)$150
Grade B (good)$137
Grade C (fair)$75

Nissan Frontier engine computer price snapshot

USD
Low
$35
Average
$154
High
$550
991 listings observed · 854 priced10d ago· How we price·

Report incorrect price

Reporting price for Nissan Frontier Engine Computer

Reason

Condition comparison

Price by part grade

Grade AClean / low wear$35–$405604 listings
Grade BStandard used$40–$395171 listings
Grade CVisible wear$75–$751 listings
Grade XUngraded$42–$55078 listings

Median by grade

Grade price comparison

Median asking price by seller-reported condition grade · $35–$550 overall range

Regional supply

Where the Nissan Frontier engine computer is listed

We found priced Nissan Frontier engine computer listings at 511 salvage yards across 45 states. Texas supplies the most, with 204 listings (12% of the total) from 42 yards. Location matters: yards in California ask a median $100, while Michigan yards ask $218, 118% more for the same part. Shipping usually costs less than that gap for smaller parts, so it can pay to buy out of state.

StateListingsYardsMedian ask
Texas20442$144-1%
California19648$100-31%
New York13718$125-14%
Florida10839$125-14%
North Carolina8222$172+19%
Michigan7325$218+50%
Tennessee5415$190+31%
Arizona5312$110-24%

States with at least 10 priced listings. % is versus the $145 national median.

Replacement cost

What is the Nissan Frontier engine computer replacement cost?

ESTIMATE
Used part
$145
Nissan Frontier median asking price
Labor
$95–$450
1–3 hours at $95–$150/hr
Estimated total
$240–$595
median used part + labor

Labor is a typical independent-shop range for engine computer replacement, not a quote for your vehicle; it does not include programming and key relearn procedure. The part price is the live median from the salvage-yard listings on this page. Full engine computer replacement cost breakdown

Sources
  1. Labor time estimates: Part Price Guide labor database

Set price alert

Alert for Nissan Frontier Engine Computer

$

Current avg: $154 — we suggest $131 (15% below)

Condition grade (optional)

Fitment matters

Price by trim & variant (2025)

Electronic Control Module, (LH engine compartment)49 listingsInterchange 2023–2025$193$85 – $280
Valve Control, (RH engine compartment)48 listingsInterchange 2024–2025$176$70 – $350

Model-year comparison

What does a Nissan Frontier engine computer cost by year?

$86$112$137$162$18720152016201720182019202020212022202320242025
Median asking price by model year · salvage yard listing data

Market analysis

How much does a used Nissan Frontier engine computer cost?

Asking prices for a used Nissan Frontier engine computer are unusually spread out: the top listing asks more than ten times what the cheapest does, so which unit you pick matters more than the median. Condition matters: grade-A units (lowest mileage, best condition) carry roughly a 100% premium over grade-C stock, with grade-A medians at $150.

Fitment variant moves the price more than most buyers expect. The most affordable variant we track, Valve Control, (RH engine compartment), lists at a $176 median, while Electronic Control Module, (LH engine compartment) commands $193, a 10% gap inside the same part category. Confirm which variant your VIN requires before comparing quotes.

Model year matters too: 2020 units carry the lowest median at $96, while 2025 tops the table at $178. Parts from 2020–2023 are interchangeable, so if the 2020 fits your vehicle, it offers the best value across 4 compatible years.

Against comparable vehicles, the Nissan Frontier sits 29% above the Honda Accord ($112), 31% above the Honda Civic ($111), and 15% above the Hyundai Elantra ($126) for the same part. The “similar vehicles” cards below open each comparison guide.

Buying a used engine computer: what to check

  1. Match hardware and service numbers: Ensure hardware revision codes and circuit board part numbers match exactly, as pinouts change mid-model year.
  2. Inspect multi-pin connector headers: Check header pins for bending, green copper oxidation, or burnt circuit board traces inside the wiring sockets.
  3. Verify immobilizer programming requirements: Plan for anti-theft security relearn procedures or ECU re-flashing before the replacement computer will start the engine.
  4. Confirm donor transmission and emissions spec: Ensure the donor vehicle used the same transmission type and regional emissions package to prevent fault codes.
  5. Check aluminum casing seals: Inspect housing screws and perimeter rubber gaskets for white oxidation or breaks that indicate past water intrusion.

Keep browsing this vehicle

What other Nissan Frontier parts are priced?

Price comparisons

Compare Nissan Frontier engine computer prices

Compare fitments

What do similar vehicles charge for this part?

Common questions

Nissan Frontier engine computer FAQ

How much is a used engine computer for a Nissan Frontier?

The median asking price is $145 across 854 priced listings from 511 yards. Grade-A units, the cleanest stock, have a median of $150. 2020 is the cheapest model year we track, with a median of $96.

How much does it cost to replace a Nissan Frontier engine computer?

Using a used part, a Nissan Frontier engine computer replacement typically runs $240–$595 all-in: the median used engine computer for this model lists at $145, and independent-shop labor for engine computer replacement typically takes 1–3 hours at $95–$150/hr ($95–$450). The labor figure does not include programming and key relearn procedure. Labor is a national part-level estimate, not a quote for your vehicle.

Which Nissan Frontier model years does this price guide cover?

This guide currently has year-level pricing for 2025, 2024, 2023, 2022, 2021, 2020, 2019, 2018, 2017, 2016, 2015. Other model years contribute to the overall range where sellers listed them without a year breakdown.

Which Nissan Frontier engine computer years are interchangeable?

Salvage-yard interchange data links Nissan Frontier engine computer fitments across 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2023, 2024, 2025. Searching all 12 years widens the pool of units; confirm the part number against your VIN, since trim or drivetrain can split an interchange group.

Used Nissan Frontier Engine Computer Cost — From $35 to $550