Jeep Gladiator engine computer price snapshot
- Low
- $40
- Average
- $200
- High
- $500

Vehicle-specific price guide
A used Jeep Gladiator engine computer costs $40 to $500, with a median asking price of $195. Based on 138 priced salvage yard listings across the US, compatible across 2020–2025 (6 model years), updated Sep 10, 2026. Prices exclude shipping, core charges, and installation.
Condition comparison
| Grade | Price range | Relative range | Listings |
|---|---|---|---|
| Grade AClean / low wear | $40–$500 | 96 | |
| Grade BStandard used | $75–$395 | 33 | |
| Grade CVisible wear | Updating | — | |
| Grade XUngraded | $96–$500 | 9 |
Median by grade
Median asking price by seller-reported condition grade · $40–$500 overall range
Replacement cost
Labor is a typical independent-shop range for engine computer replacement, not a quote for your vehicle; it does not include programming and key relearn procedure. The part price is the live median from the salvage-yard listings on this page. Full engine computer replacement cost breakdown
Fitment matters
Model-year comparison
Market analysis
The going rate for a used Jeep Gladiator engine computer is $195 at the median, with listings spanning $40 to $500. That figure comes from 138 priced salvage-yard listings tracked by our index. Condition matters: grade-A units (lowest mileage, best condition) carry roughly a 6% premium over grade-B stock, with grade-A medians at $200.
Fitment variant moves the price more than most buyers expect. The most affordable variant we track, Electronic Control Module, (LH engine compartment), 3.6L (gasoline), opt NZB (GPEC 2A engine controller), lists at a $170 median, while Electronic Control Module, (LH engine compartment), 3.6L (gasoline), opt NZE (GPEC 5 engine controller) commands $211, a 24% gap inside the same part category. Confirm which variant your VIN requires before comparing quotes.
Against comparable vehicles, the Jeep Gladiator sits 77% above the Honda Accord ($110), 34% above the Hyundai Elantra ($146), and 56% above the Honda Civic ($125) for the same part. The “similar vehicles” cards below open each comparison guide.
Keep browsing this vehicle


Price data updating










Price data updating


Price data updating












Price data updating













Price data updating

Price data updating














Price comparisons
Compare fitments
Common questions
Based on 138 priced salvage yard listings, a used Jeep Gladiator engine computer lists between $40 and $500, with a median asking price of $195.
Using a used part, a Jeep Gladiator engine computer replacement typically runs $290–$645 all-in: the median used engine computer for this model lists at $195, and independent-shop labor for engine computer replacement typically takes 1–3 hours at $95–$150/hr ($95–$450). The labor figure does not include programming and key relearn procedure. Labor is a national part-level estimate, not a quote for your vehicle.
Condition grade, mileage, model year, and fitment variant all move the price. Our data covers 3 distinct trims/variants for this part. Check the variant table above, since interchange differences can change the price substantially. Always confirm fitment against your VIN or part number before buying.
This guide currently has year-level pricing for 2023. Other model years contribute to the overall range where sellers listed them without a year breakdown.
Based on salvage-yard interchange data, Jeep Gladiator engine computer listings appear across model years 2020, 2021, 2022, 2023, 2024, 2025, suggesting these years share compatible fitments. Shopping across all 6 years may surface better prices or grades. Always verify the exact part number and VIN before buying — interchange compatibility can vary by trim or drivetrain.
A ecu is another name for a engine computer. The Jeep Gladiator engine computer prices on this page apply — median $195, from 138 salvage yard listings.