Used Jeep Gladiator axle shaft from a salvage yard

Vehicle-specific price guide

How much is a used Jeep Gladiator axle shaft?

Asking prices from 151 salvage yards in 40 states, broken down by model year, condition grade, and fitment variant.
SKWritten bySaurabh Kumar · Co-Founder & CTO
ASReviewed byAmbika Sharma · Co-Founder & COO
Last updatedSep 21, 2026
Strong coverage1,496 priced of 1,734 observed2 variantsMethodology v2.1 →

Part overview

About the Jeep Gladiator axle shaft

What the axle shaft does, common failure signs, and prices across all vehicles: used axle shaft price guide →

Also known asCV AxleCV ShaftDrive AxleHalf ShaftAxle AssemblyCovers front CV axles and rear axle shafts.
Price summary

A used Jeep Gladiator axle shaft costs $70 to $935, with a median asking price of $275. Based on 1,496 priced salvage yard listings across the US, compatible across 2018–2025 (8 model years), updated Sep 21, 2026. Prices exclude shipping, core charges, and installation.

Grade A (excellent)$288
Grade B (good)$225

Jeep Gladiator axle shaft price snapshot

USD
Low
$70
Average
$305
High
$935
1,734 listings observed · 1,496 priced1mo ago· How we price·

Report incorrect price

Reporting price for Jeep Gladiator Axle Shaft

Reason

Condition comparison

Price by part grade

Grade AClean / low wear$70–$6871,102 listings
Grade BStandard used$94–$430263 listings
Grade XUngraded$70–$935131 listings

Median by grade

Grade price comparison

Median asking price by seller-reported condition grade · $70–$935 overall range

Regional supply

Where the Jeep Gladiator axle shaft is listed

We found priced Jeep Gladiator axle shaft listings at 151 salvage yards across 40 states. Michigan supplies the most, with 193 listings (13% of the total) from 18 yards. Location matters: yards in Indiana ask a median $200, while Wisconsin yards ask $349, 75% more for the same part. Shipping usually costs less than that gap for smaller parts, so it can pay to buy out of state.

StateListingsYardsMedian ask
Michigan19318$275
Florida1368$313+14%
Indiana1159$200-27%
Missouri1088$302+10%
Wisconsin9810$349+27%
Texas747$313+14%
Mississippi623$260-5%
New York574$250-9%

States with at least 10 priced listings. % is versus the $275 national median.

Replacement cost

What is the Jeep Gladiator axle shaft replacement cost?

ESTIMATE
Used part
$275
Jeep Gladiator median asking price
Labor
$95–$375
1–2.5 hours at $95–$150/hr
Estimated total
$370–$650
median used part + labor

Labor is a typical independent-shop range for axle shaft replacement, not a quote for your vehicle. The part price is the live median from the salvage-yard listings on this page. How we price

Sources
  1. Labor time estimates: Part Price Guide labor database

Set price alert

Alert for Jeep Gladiator Axle Shaft

$

Current avg: $305 — we suggest $259 (15% below)

Condition grade (optional)

Fitment matters

Price by trim & variant (2025)

Non-Interchange search using Jeep Gladiator and similar models

1 listings
$300$300 – $300

Non-Interchange search using only Jeep Gladiator

1 listings
$300$300 – $300

Model-year comparison

What does a Jeep Gladiator axle shaft cost by year?

$238$257$276$296$315202020212022202320242025
Median asking price by model year · salvage yard listing data

Market analysis

How much does a used Jeep Gladiator axle shaft cost?

Asking prices for a used Jeep Gladiator axle shaft are unusually spread out: the top listing asks more than ten times what the cheapest does, so which unit you pick matters more than the median. Condition matters: grade-A units (lowest mileage, best condition) carry roughly a 28% premium over grade-B stock, with grade-A medians at $288.

Model year matters too: 2024 units carry the lowest median at $264, while 2025 tops the table at $300. Parts from 2018–2024 are interchangeable, so if the 2024 fits your vehicle, it offers the best value across 7 compatible years.

Against comparable vehicles, the Jeep Gladiator sits 4% below the Mercedes GLE Class ($287), 36% above the Mercedes C Class ($202), and 32% above the Mercedes E Class ($209) for the same part. The “similar vehicles” cards below open each comparison guide.

Buying a used axle shaft: what to check

  1. Inspect CV boots for cracks. A torn boot means the joint has likely ingested grit.
  2. Confirm ABS ring compatibility with your sensor setup.
  3. Left and right shafts usually differ in length, so verify the side.
  4. Spin the joints through full articulation and listen for clicking.

Keep browsing this vehicle

What other Jeep Gladiator parts are priced?

Price comparisons

Compare Jeep Gladiator axle shaft prices

Compare fitments

What do similar vehicles charge for this part?

Common questions

Jeep Gladiator axle shaft FAQ

How much is a used axle shaft for a Jeep Gladiator?

The median asking price is $275 across 1,496 priced listings from 151 yards. Grade-A units, the cleanest stock, have a median of $288. 2024 is the cheapest model year we track, with a median of $264.

How much does it cost to replace a Jeep Gladiator axle shaft?

Using a used part, a Jeep Gladiator axle shaft replacement typically runs $370–$650 all-in: the median used axle shaft for this model lists at $275, and independent-shop labor for axle shaft replacement typically takes 1–2.5 hours at $95–$150/hr ($95–$375). Labor is a national part-level estimate, not a quote for your vehicle.

Which Jeep Gladiator model years does this price guide cover?

This guide currently has year-level pricing for 2025, 2024, 2023, 2022, 2021, 2020. Other model years contribute to the overall range where sellers listed them without a year breakdown.

Which Jeep Gladiator axle shaft years are interchangeable?

Salvage-yard interchange data links Jeep Gladiator axle shaft fitments across 2018, 2019, 2020, 2021, 2022, 2023, 2024, 2025. Searching all 8 years widens the pool of units; confirm the part number against your VIN, since trim or drivetrain can split an interchange group.

Used Jeep Gladiator Axle Shaft Cost — From $70 to $935