Used Tesla Model 3 master cylinder from a salvage yard

Vehicle-specific price guide

How much is a used Tesla Model 3 master cylinder?

Asking prices from 85 salvage yards in 23 states, broken down by model year, condition grade, and fitment variant.
SKWritten bySaurabh Kumar · Co-Founder & CTO
ASReviewed byAmbika Sharma · Co-Founder & COO
Last updatedOct 22, 2026
Strong coverage218 priced of 367 observed2 variantsMethodology v2.1 →

Part overview

About the Tesla Model 3 master cylinder

What the master cylinder does, common failure signs, and prices across all vehicles: used master cylinder price guide →

Also known asBrake Master Cylinder
Price summary

A used Tesla Model 3 master cylinder costs $35 to $424, with a median asking price of $124. Based on 218 priced salvage yard listings across the US, compatible across 2015–2025 (8 model years), updated Oct 22, 2026. Prices exclude shipping, core charges, and installation.

Grade A (excellent)$150
Grade B (good)$120

Tesla Model 3 master cylinder price snapshot

USD
Low
$35
Average
$157
High
$424
367 listings observed · 218 priced10d ago· How we price·

Report incorrect price

Reporting price for Tesla Model 3 Master Cylinder

Reason

Condition comparison

Price by part grade

Grade AClean / low wear$50–$424134 listings
Grade BStandard used$65–$26450 listings
Grade XUngraded$35–$28434 listings

Median by grade

Grade price comparison

Median asking price by seller-reported condition grade · $35–$424 overall range

Regional supply

Where the Tesla Model 3 master cylinder is listed

We found priced Tesla Model 3 master cylinder listings at 85 salvage yards across 23 states. California supplies the most, with 26 listings (10% of the total) from 7 yards. Location matters: yards in California ask a median $65, while Michigan yards ask $265, 308% more for the same part. Shipping usually costs less than that gap for smaller parts, so it can pay to buy out of state.

StateListingsYardsMedian ask
California267$65-48%
Texas238$100-19%
Michigan209$265+114%
Wisconsin137$261+110%
New York125$65-48%
Florida125$264+113%
Utah101$85-31%
Virginia101$150+21%

States with at least 10 priced listings. % is versus the $124 national median.

Replacement cost

What is the Tesla Model 3 master cylinder replacement cost?

ESTIMATE
Used part
$124
Tesla Model 3 median asking price
Labor
$145–$450
1.5–3 hours at $95–$150/hr
Estimated total
$270–$575
median used part + labor

Labor is a typical independent-shop range for master cylinder replacement, not a quote for your vehicle; it does not include brake fluid and full system bleed at all four wheels. The part price is the live median from the salvage-yard listings on this page. Full master cylinder replacement cost breakdown

Sources
  1. Labor time estimates: Part Price Guide labor database

Set price alert

Alert for Tesla Model 3 Master Cylinder

$

Current avg: $157 — we suggest $133 (15% below)

Condition grade (optional)

Fitment matters

Price by trim & variant (2025)

Model-year comparison

What does a Tesla Model 3 master cylinder cost by year?

$68$129$191$253$3152018201920212022202320242025
Median asking price by model year · salvage yard listing data

Market analysis

How much does a used Tesla Model 3 master cylinder cost?

Asking prices for a used Tesla Model 3 master cylinder are unusually spread out: the top listing asks more than ten times what the cheapest does, so which unit you pick matters more than the median. Condition matters: grade-A units (lowest mileage, best condition) carry roughly a 25% premium over grade-B stock, with grade-A medians at $150.

Model year matters too: 2021 units carry the lowest median at $75, while 2024 tops the table at $300. Year-level pages linked in the table above break each one down by grade and variant.

Against comparable vehicles, the Tesla Model 3 sits 50% below the Nissan Titan ($250), 91% above the Ford Mustang ($65), and 94% above the Honda Civic ($64) for the same part. The “similar vehicles” cards below open each comparison guide.

Buying a used master cylinder: what to check

  1. Inspect rear piston seal for fluid leaks: Check the rear mounting flange for wet fluid leakage that damages power brake booster rubber diaphragms.
  2. Verify reservoir clarity and mounting grommets: Inspect the plastic fluid reservoir for sun-embrittled walls, cracks, or hardened rubber mounting grommets.
  3. Check brake line port thread types: Verify whether hydraulic output ports use metric bubble flares or inverted flare threads before connecting brake lines.
  4. Confirm fluid level sensor plug condition: Check the fluid level float switch connector for corrosion or broken locking tabs to avoid low-fluid dash warnings.
  5. Bench bleed before vehicle installation: Purge trapped air from internal piston chambers using a bench bleed kit before attaching vehicle brake lines.

Keep browsing this vehicle

What other Tesla Model 3 parts are priced?

Price comparisons

Compare Tesla Model 3 master cylinder prices

Compare fitments

What do similar vehicles charge for this part?

Common questions

Tesla Model 3 master cylinder FAQ

How much is a used master cylinder for a Tesla Model 3?

The median asking price is $124 across 218 priced listings from 85 yards. Grade-A units, the cleanest stock, have a median of $150. 2021 is the cheapest model year we track, with a median of $75.

How much does it cost to replace a Tesla Model 3 master cylinder?

Using a used part, a Tesla Model 3 master cylinder replacement typically runs $270–$575 all-in: the median used master cylinder for this model lists at $124, and independent-shop labor for master cylinder replacement typically takes 1.5–3 hours at $95–$150/hr ($145–$450). The labor figure does not include brake fluid and full system bleed at all four wheels. Labor is a national part-level estimate, not a quote for your vehicle.

Which Tesla Model 3 model years does this price guide cover?

This guide currently has year-level pricing for 2025, 2024, 2023, 2022, 2021, 2019, 2018, 2015. Other model years contribute to the overall range where sellers listed them without a year breakdown.

Which Tesla Model 3 master cylinder years are interchangeable?

Salvage-yard interchange data links Tesla Model 3 master cylinder fitments across 2015, 2018, 2019, 2021, 2022, 2023, 2024, 2025. Searching all 8 years widens the pool of units; confirm the part number against your VIN, since trim or drivetrain can split an interchange group.

Used Tesla Model 3 Master Cylinder Cost — From $35 to $424