Used Chevy Malibu axle shaft from a salvage yard

Vehicle-specific price guide

How much is a used Chevy Malibu axle shaft?

Asking prices from 582 salvage yards in 45 states, broken down by model year, condition grade, and fitment variant.
SKWritten bySaurabh Kumar · Co-Founder & CTO
ASReviewed byAmbika Sharma · Co-Founder & COO
Last updatedOct 24, 2026
Strong coverage2,105 priced of 2,854 observed2 variantsMethodology v2.1 →

Part overview

About the Chevy Malibu axle shaft

What the axle shaft does, common failure signs, and prices across all vehicles: used axle shaft price guide →

Also known asCV AxleCV ShaftDrive AxleHalf ShaftAxle AssemblyCovers front CV axles and rear axle shafts.
Price summary

A used Chevy Malibu axle shaft costs $30 to $415, with a median asking price of $90. Based on 2,105 priced salvage yard listings across the US, compatible across 2010–2025 (16 model years), updated Oct 24, 2026. Prices exclude shipping, core charges, and installation.

Grade A (excellent)$97
Grade B (good)$99
Grade C (fair)$50

Chevy Malibu axle shaft price snapshot

USD
Low
$30
Average
$113
High
$415
2,854 listings observed · 2,105 priced7d ago· How we price·

Report incorrect price

Reporting price for Chevy Malibu Axle Shaft

Reason

Condition comparison

Price by part grade

Grade AClean / low wear$30–$4151,257 listings
Grade BStandard used$36–$385730 listings
Grade CVisible wear$35–$10011 listings
Grade XUngraded$35–$100107 listings

Median by grade

Grade price comparison

Median asking price by seller-reported condition grade · $30–$415 overall range

Regional supply

Where the Chevy Malibu axle shaft is listed

We found priced Chevy Malibu axle shaft listings at 582 salvage yards across 45 states. Illinois supplies the most, with 676 listings (14% of the total) from 32 yards. Location matters: yards in California ask a median $65, while Kentucky yards ask $164, 152% more for the same part. Shipping usually costs less than that gap for smaller parts, so it can pay to buy out of state.

StateListingsYardsMedian ask
Illinois67632$131+46%
California54740$65-28%
Texas42846$87-3%
Michigan35544$86-4%
Kentucky23919$164+82%
Ohio18925$93+3%
Virginia18114$134+49%
Georgia18018$129+43%

States with at least 10 priced listings. % is versus the $90 national median.

Replacement cost

What is the Chevy Malibu axle shaft replacement cost?

ESTIMATE
Used part
$90
Chevy Malibu median asking price
Labor
$95–$375
1–2.5 hours at $95–$150/hr
Estimated total
$185–$465
median used part + labor

Labor is a typical independent-shop range for axle shaft replacement, not a quote for your vehicle. The part price is the live median from the salvage-yard listings on this page. How we price

Sources
  1. Labor time estimates: Part Price Guide labor database

Set price alert

Alert for Chevy Malibu Axle Shaft

$

Current avg: $113 — we suggest $96 (15% below)

Condition grade (optional)

Fitment matters

Price by trim & variant (2025)

(front axle), RH43 listingsInterchange 2019–2024$190$48 – $190
(front axle), LH41 listingsInterchange 2019–2024$190$77 – $201

Model-year comparison

What does a Chevy Malibu axle shaft cost by year?

$68$101$134$167$20020152016201720182019202020212022202320242025
Median asking price by model year · salvage yard listing data

Market analysis

How much does a used Chevy Malibu axle shaft cost?

Asking prices for a used Chevy Malibu axle shaft are unusually spread out: the top listing asks more than ten times what the cheapest does, so which unit you pick matters more than the median. Condition matters: grade-A units (lowest mileage, best condition) carry roughly a 94% premium over grade-C stock, with grade-A medians at $97.

Model year matters too: 2017 units carry the lowest median at $75, while 2015 tops the table at $190. Parts from 2016–2022 are interchangeable, so if the 2017 fits your vehicle, it offers the best value across 7 compatible years.

Against comparable vehicles, the Chevy Malibu sits 69% below the Mercedes GLE Class ($287), 55% below the Mercedes C Class ($202), and 57% below the Mercedes E Class ($209) for the same part. The “similar vehicles” cards below open each comparison guide.

Buying a used axle shaft: what to check

  1. Inspect CV boots for cracks. A torn boot means the joint has likely ingested grit.
  2. Confirm ABS ring compatibility with your sensor setup.
  3. Left and right shafts usually differ in length, so verify the side.
  4. Spin the joints through full articulation and listen for clicking.

Keep browsing this vehicle

What other Chevy Malibu parts are priced?

Price comparisons

Compare Chevy Malibu axle shaft prices

Compare fitments

What do similar vehicles charge for this part?

Common questions

Chevy Malibu axle shaft FAQ

How much is a used axle shaft for a Chevy Malibu?

The median asking price is $90 across 2,105 priced listings from 582 yards. Grade-A units, the cleanest stock, have a median of $97. 2022 is the cheapest model year we track, with a median of $75.

How much does it cost to replace a Chevy Malibu axle shaft?

Using a used part, a Chevy Malibu axle shaft replacement typically runs $185–$465 all-in: the median used axle shaft for this model lists at $90, and independent-shop labor for axle shaft replacement typically takes 1–2.5 hours at $95–$150/hr ($95–$375). Labor is a national part-level estimate, not a quote for your vehicle.

Which Chevy Malibu model years does this price guide cover?

This guide currently has year-level pricing for 2025, 2024, 2023, 2022, 2021, 2020, 2019, 2018, 2017, 2016, 2015. Other model years contribute to the overall range where sellers listed them without a year breakdown.

Which Chevy Malibu axle shaft years are interchangeable?

Salvage-yard interchange data links Chevy Malibu axle shaft fitments across 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2023, 2024, 2025. Searching all 16 years widens the pool of units; confirm the part number against your VIN, since trim or drivetrain can split an interchange group.

Used Chevy Malibu Axle Shaft Cost — From $30 to $415