Used Acura RDX drive shaft from a salvage yard

Vehicle-specific price guide

How much is a used Acura RDX drive shaft?

Asking prices from 239 salvage yards in 37 states, broken down by model year, condition grade, and fitment variant.
SKWritten bySaurabh Kumar · Co-Founder & CTO
ASReviewed byAmbika Sharma · Co-Founder & COO
Last updatedOct 22, 2026
Strong coverage522 priced of 550 observed0 variantsMethodology v2.1 →

Part overview

About the Acura RDX drive shaft

What the drive shaft does, common failure signs, and prices across all vehicles: used drive shaft price guide →

Also known asDriveshaftPropeller ShaftProp Shaft
Price summary

A used Acura RDX drive shaft costs $60 to $450, with a median asking price of $173. Based on 522 priced salvage yard listings across the US, compatible across 2013–2025 (13 model years), updated Oct 22, 2026. Prices exclude shipping, core charges, and installation.

Grade A (excellent)$184
Grade B (good)$141

Acura RDX drive shaft price snapshot

USD
Low
$60
Average
$184
High
$450
550 listings observed · 522 priced10d ago· How we price·

Report incorrect price

Reporting price for Acura RDX Drive Shaft

Reason

Condition comparison

Price by part grade

Grade AClean / low wear$70–$450410 listings
Grade BStandard used$75–$420101 listings
Grade XUngraded$60–$30011 listings

Median by grade

Grade price comparison

Median asking price by seller-reported condition grade · $60–$450 overall range

Regional supply

Where the Acura RDX drive shaft is listed

We found priced Acura RDX drive shaft listings at 239 salvage yards across 37 states. Illinois supplies the most, with 144 listings (12% of the total) from 16 yards. Location matters: yards in New York ask a median $111, while Michigan yards ask $207, 86% more for the same part. Shipping usually costs less than that gap for smaller parts, so it can pay to buy out of state.

StateListingsYardsMedian ask
Illinois14416$184+6%
New York11816$111-36%
Wisconsin9611$145-16%
Connecticut8413$160-8%
California7416$125-28%
Michigan6412$207+20%
Pennsylvania519$191+10%
Indiana509$201+16%

States with at least 10 priced listings. % is versus the $173 national median.

Replacement cost

What is the Acura RDX drive shaft replacement cost?

ESTIMATE
Used part
$173
Acura RDX median asking price
Labor
$95–$450
1–3 hours at $95–$150/hr
Estimated total
$270–$625
median used part + labor

Labor is a typical independent-shop range for drive shaft replacement, not a quote for your vehicle. The part price is the live median from the salvage-yard listings on this page. Full drive shaft replacement cost breakdown

Sources
  1. Labor time estimates: Part Price Guide labor database

Set price alert

Alert for Acura RDX Drive Shaft

$

Current avg: $184 — we suggest $156 (15% below)

Condition grade (optional)

Model-year comparison

What does a Acura RDX drive shaft cost by year?

$112$136$161$185$21020152016201720182019202020212022202320242025
Median asking price by model year · salvage yard listing data

Market analysis

How much does a used Acura RDX drive shaft cost?

Asking prices for a used Acura RDX drive shaft are unusually spread out: the top listing asks about 8 times what the cheapest does, so which unit you pick matters more than the median. Condition matters: grade-A units (lowest mileage, best condition) carry roughly a 30% premium over grade-B stock, with grade-A medians at $184.

Model year matters too: 2015 units carry the lowest median at $124, while 2020 tops the table at $200. Parts from 2013–2018 are interchangeable, so if the 2015 fits your vehicle, it offers the best value across 6 compatible years.

Against comparable vehicles, the Acura RDX sits 9% below the Ram 1500 ($190), 24% below the Chevy Silverado 1500 ($228), and 29% below the GMC Sierra 1500 ($243) for the same part. The “similar vehicles” cards below open each comparison guide.

Buying a used drive shaft: what to check

  1. Flex universal joints and CV boots: Articulate each U-joint by hand to check for stiff binding, rusted needle bearings, or torn rubber constant-velocity boots.
  2. Inspect slip yoke splines and balance weights: Check male splines for twisting or galling, and verify that welded steel balance weights are present along the tube.
  3. Examine center carrier bearing rubber: Inspect two-piece driveshaft center bearings for cracked rubber mounting rings or noisy, dry support bearings.
  4. Measure overall compressed length: Verify flange-to-flange operating length exactly, as transmission options and wheelbase variations alter shaft dimensions.
  5. Index flange alignment before installation: Mark mating yokes to the differential flange before installation to prevent high-speed driveline vibration.

Keep browsing this vehicle

What other Acura RDX parts are priced?

Price comparisons

Compare Acura RDX drive shaft prices

Compare fitments

What do similar vehicles charge for this part?

Common questions

Acura RDX drive shaft FAQ

How much is a used drive shaft for a Acura RDX?

The median asking price is $173 across 522 priced listings from 239 yards. Grade-A units, the cleanest stock, have a median of $184. 2016 is the cheapest model year we track, with a median of $124.

How much does it cost to replace a Acura RDX drive shaft?

Using a used part, a Acura RDX drive shaft replacement typically runs $270–$625 all-in: the median used drive shaft for this model lists at $173, and independent-shop labor for drive shaft replacement typically takes 1–3 hours at $95–$150/hr ($95–$450). Labor is a national part-level estimate, not a quote for your vehicle.

Which Acura RDX model years does this price guide cover?

This guide currently has year-level pricing for 2025, 2024, 2023, 2022, 2021, 2020, 2019, 2018, 2017, 2016, 2015. Other model years contribute to the overall range where sellers listed them without a year breakdown.

Which Acura RDX drive shaft years are interchangeable?

Salvage-yard interchange data links Acura RDX drive shaft fitments across 2013, 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2023, 2024, 2025. Searching all 13 years widens the pool of units; confirm the part number against your VIN, since trim or drivetrain can split an interchange group.

Used Acura RDX Drive Shaft Cost — From $60 to $450