Used Buick Envision drive shaft from a salvage yard

Vehicle-specific price guide

How much is a used Buick Envision drive shaft?

Asking prices from 108 salvage yards in 22 states, broken down by model year, condition grade, and fitment variant.
SKWritten bySaurabh Kumar · Co-Founder & CTO
ASReviewed byAmbika Sharma · Co-Founder & COO
Last updatedOct 17, 2026
Strong coverage520 priced of 544 observed5 variantsMethodology v2.1 →

Part overview

About the Buick Envision drive shaft

What the drive shaft does, common failure signs, and prices across all vehicles: used drive shaft price guide →

Also known asDriveshaftPropeller ShaftProp Shaft
Price summary

A used Buick Envision drive shaft costs $80 to $420, with a median asking price of $172. Based on 520 priced salvage yard listings across the US, compatible across 2016–2025 (10 model years), updated Oct 17, 2026. Prices exclude shipping, core charges, and installation.

Grade A (excellent)$166
Grade B (good)$206

Buick Envision drive shaft price snapshot

USD
Low
$80
Average
$180
High
$420
544 listings observed · 520 priced11d ago· How we price·

Report incorrect price

Reporting price for Buick Envision Drive Shaft

Reason

Condition comparison

Price by part grade

Grade AClean / low wear$80–$420401 listings
Grade BStandard used$100–$370112 listings
Grade XUngraded$110–$1507 listings

Median by grade

Grade price comparison

Median asking price by seller-reported condition grade · $80–$420 overall range

Regional supply

Where the Buick Envision drive shaft is listed

We found priced Buick Envision drive shaft listings at 108 salvage yards across 22 states. Texas supplies the most, with 194 listings (37% of the total) from 24 yards. Location matters: yards in Utah ask a median $150, while California yards ask $221, 47% more for the same part. Shipping usually costs less than that gap for smaller parts, so it can pay to buy out of state.

StateListingsYardsMedian ask
Texas19424$190+10%
Colorado7810$157-9%
Oklahoma547$176+2%
California3513$221+28%
Utah226$150-13%
Arizona225$155-10%
Idaho214$185+8%
Missouri164$165-4%

States with at least 10 priced listings. % is versus the $172 national median.

Replacement cost

What is the Buick Envision drive shaft replacement cost?

ESTIMATE
Used part
$172
Buick Envision median asking price
Labor
$95–$450
1–3 hours at $95–$150/hr
Estimated total
$265–$620
median used part + labor

Labor is a typical independent-shop range for drive shaft replacement, not a quote for your vehicle. The part price is the live median from the salvage-yard listings on this page. Full drive shaft replacement cost breakdown

Sources
  1. Labor time estimates: Part Price Guide labor database

Set price alert

Alert for Buick Envision Drive Shaft

$

Current avg: $180 — we suggest $153 (15% below)

Condition grade (optional)

Fitment matters

Price by trim & variant (2022)

(AWD), ID 313511 listingsInterchange 2023–2024$148$115 – $285
(AWD), ID AB5F11 listingsInterchange 2023–2024$148$115 – $285
(AWD), ID AB9K11 listingsInterchange 2023–2024$148$115 – $285
(AWD), ID ACDS11 listingsInterchange 2023–2024$148$115 – $285

(AWD), ID 87823136

3 listings
$193$100 – $235

Model-year comparison

What does a Buick Envision drive shaft cost by year?

$133$149$165$181$1972016201720182019202020212022202320242025
Median asking price by model year · salvage yard listing data

Market analysis

How much does a used Buick Envision drive shaft cost?

Asking prices for a used Buick Envision drive shaft are unusually spread out: the top listing asks about 5 times what the cheapest does, so which unit you pick matters more than the median.

Fitment variant moves the price more than most buyers expect. The most affordable variant we track, (AWD), ID 3135, lists at a $148 median, while (AWD), ID 87823136 commands $193, a 30% gap inside the same part category. Confirm which variant your VIN requires before comparing quotes.

Model year matters too: 2022 units carry the lowest median at $148, while 2025 tops the table at $188. Parts from 2022–2024 are interchangeable, so if the 2022 fits your vehicle, it offers the best value across 3 compatible years.

Against comparable vehicles, the Buick Envision sits 9% below the Ram 1500 ($190), 25% below the Chevy Silverado 1500 ($228), and 29% below the GMC Sierra 1500 ($243) for the same part. The “similar vehicles” cards below open each comparison guide.

Buying a used drive shaft: what to check

  1. Flex universal joints and CV boots: Articulate each U-joint by hand to check for stiff binding, rusted needle bearings, or torn rubber constant-velocity boots.
  2. Inspect slip yoke splines and balance weights: Check male splines for twisting or galling, and verify that welded steel balance weights are present along the tube.
  3. Examine center carrier bearing rubber: Inspect two-piece driveshaft center bearings for cracked rubber mounting rings or noisy, dry support bearings.
  4. Measure overall compressed length: Verify flange-to-flange operating length exactly, as transmission options and wheelbase variations alter shaft dimensions.
  5. Index flange alignment before installation: Mark mating yokes to the differential flange before installation to prevent high-speed driveline vibration.

Keep browsing this vehicle

What other Buick Envision parts are priced?

Price comparisons

Compare Buick Envision drive shaft prices

Compare fitments

What do similar vehicles charge for this part?

Common questions

Buick Envision drive shaft FAQ

How much is a used drive shaft for a Buick Envision?

The median asking price is $172 across 520 priced listings from 108 yards. Grade-A units, the cleanest stock, have a median of $166. 2022 is the cheapest model year we track, with a median of $148.

How much does it cost to replace a Buick Envision drive shaft?

Using a used part, a Buick Envision drive shaft replacement typically runs $265–$620 all-in: the median used drive shaft for this model lists at $172, and independent-shop labor for drive shaft replacement typically takes 1–3 hours at $95–$150/hr ($95–$450). Labor is a national part-level estimate, not a quote for your vehicle.

Which Buick Envision model years does this price guide cover?

This guide currently has year-level pricing for 2025, 2024, 2023, 2022, 2021, 2020, 2019, 2018, 2017, 2016. Other model years contribute to the overall range where sellers listed them without a year breakdown.

Which Buick Envision drive shaft years are interchangeable?

Salvage-yard interchange data links Buick Envision drive shaft fitments across 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2023, 2024, 2025. Searching all 10 years widens the pool of units; confirm the part number against your VIN, since trim or drivetrain can split an interchange group.

Used Buick Envision Drive Shaft Cost — From $80 to $420