Used Dodge Durango drive shaft from a salvage yard

Vehicle-specific price guide

How much is a used Dodge Durango drive shaft?

Asking prices from 402 salvage yards in 44 states, broken down by model year, condition grade, and fitment variant.
SKWritten bySaurabh Kumar · Co-Founder & CTO
ASReviewed byAmbika Sharma · Co-Founder & COO
Last updatedOct 22, 2026
Strong coverage1,611 priced of 2,145 observed5 variantsMethodology v2.1 →

Part overview

About the Dodge Durango drive shaft

What the drive shaft does, common failure signs, and prices across all vehicles: used drive shaft price guide →

Also known asDriveshaftPropeller ShaftProp Shaft
Price summary

A used Dodge Durango drive shaft costs $61 to $975, with a median asking price of $211. Based on 1,611 priced salvage yard listings across the US, compatible across 2011–2025 (15 model years), updated Oct 22, 2026. Prices exclude shipping, core charges, and installation.

Grade A (excellent)$221
Grade B (good)$194
Grade C (fair)$125

Dodge Durango drive shaft price snapshot

USD
Low
$61
Average
$254
High
$975
2,145 listings observed · 1,611 priced9d ago· How we price·

Report incorrect price

Reporting price for Dodge Durango Drive Shaft

Reason

Condition comparison

Price by part grade

Grade AClean / low wear$61–$9751,093 listings
Grade BStandard used$61–$491353 listings
Grade CVisible wear$86–$25016 listings
Grade XUngraded$70–$650149 listings

Median by grade

Grade price comparison

Median asking price by seller-reported condition grade · $61–$975 overall range

Regional supply

Where the Dodge Durango drive shaft is listed

We found priced Dodge Durango drive shaft listings at 402 salvage yards across 44 states. Texas supplies the most, with 311 listings (14% of the total) from 33 yards. Location matters: yards in Arizona ask a median $155, while Michigan yards ask $313, 102% more for the same part. Shipping usually costs less than that gap for smaller parts, so it can pay to buy out of state.

StateListingsYardsMedian ask
Texas31133$200-5%
California27836$188-11%
Arizona21713$155-27%
Illinois14323$195-8%
Florida13321$311+47%
Utah936$211
Michigan8424$313+48%
Georgia7616$250+18%

States with at least 10 priced listings. % is versus the $211 national median.

Replacement cost

What is the Dodge Durango drive shaft replacement cost?

ESTIMATE
Used part
$211
Dodge Durango median asking price
Labor
$95–$450
1–3 hours at $95–$150/hr
Estimated total
$305–$660
median used part + labor

Labor is a typical independent-shop range for drive shaft replacement, not a quote for your vehicle. The part price is the live median from the salvage-yard listings on this page. Full drive shaft replacement cost breakdown

Sources
  1. Labor time estimates: Part Price Guide labor database

Set price alert

Alert for Dodge Durango Drive Shaft

$

Current avg: $254 — we suggest $216 (15% below)

Condition grade (optional)

Fitment matters

Price by trim & variant (2025)

195mm ring gear (7.68", opt DRH)34 listingsInterchange 2011–2022$143$68 – $513
230mm ring gear (9.06", opt DR1), 4x4, 5.7L32 listingsInterchange 2011–2024$211$100 – $500
230mm ring gear (9.06", opt DR1), 4x2, 5.7L22 listingsInterchange 2014–2023$250$175 – $650
230mm ring gear (9.06", opt DR1), 4x2, 3.6L9 listingsInterchange 2014–2021$325$75 – $377
230mm ring gear (9.06", opt DR1), 4x4, 6.2L9 listingsInterchange 2021–2022$265$100 – $351

Model-year comparison

What does a Dodge Durango drive shaft cost by year?

$180$206$233$259$28620152016201720182019202020212022202320242025
Median asking price by model year · salvage yard listing data

Market analysis

How much does a used Dodge Durango drive shaft cost?

Asking prices for a used Dodge Durango drive shaft are unusually spread out: the top listing asks more than ten times what the cheapest does, so which unit you pick matters more than the median. Condition matters: grade-A units (lowest mileage, best condition) carry roughly a 77% premium over grade-C stock, with grade-A medians at $221.

Fitment variant moves the price more than most buyers expect. The most affordable variant we track, 195mm ring gear (7.68", opt DRH), lists at a $143 median, while 230mm ring gear (9.06", opt DR1), 4x2, 3.6L commands $325, a 127% gap inside the same part category. Confirm which variant your VIN requires before comparing quotes.

Model year matters too: 2015 units carry the lowest median at $200, while 2021 tops the table at $272. Parts from 2011–2024 are interchangeable, so if the 2015 fits your vehicle, it offers the best value across 14 compatible years.

Against comparable vehicles, the Dodge Durango sits 11% above the Ram 1500 ($190), 7% below the Chevy Silverado 1500 ($228), and 13% below the GMC Sierra 1500 ($243) for the same part. The “similar vehicles” cards below open each comparison guide.

Buying a used drive shaft: what to check

  1. Flex universal joints and CV boots: Articulate each U-joint by hand to check for stiff binding, rusted needle bearings, or torn rubber constant-velocity boots.
  2. Inspect slip yoke splines and balance weights: Check male splines for twisting or galling, and verify that welded steel balance weights are present along the tube.
  3. Examine center carrier bearing rubber: Inspect two-piece driveshaft center bearings for cracked rubber mounting rings or noisy, dry support bearings.
  4. Measure overall compressed length: Verify flange-to-flange operating length exactly, as transmission options and wheelbase variations alter shaft dimensions.
  5. Index flange alignment before installation: Mark mating yokes to the differential flange before installation to prevent high-speed driveline vibration.

Keep browsing this vehicle

What other Dodge Durango parts are priced?

Price comparisons

Compare Dodge Durango drive shaft prices

Compare fitments

What do similar vehicles charge for this part?

Common questions

Dodge Durango drive shaft FAQ

How much is a used drive shaft for a Dodge Durango?

The median asking price is $211 across 1,611 priced listings from 402 yards. Grade-A units, the cleanest stock, have a median of $221. 2024 is the cheapest model year we track, with a median of $200.

How much does it cost to replace a Dodge Durango drive shaft?

Using a used part, a Dodge Durango drive shaft replacement typically runs $305–$660 all-in: the median used drive shaft for this model lists at $211, and independent-shop labor for drive shaft replacement typically takes 1–3 hours at $95–$150/hr ($95–$450). Labor is a national part-level estimate, not a quote for your vehicle.

Which Dodge Durango model years does this price guide cover?

This guide currently has year-level pricing for 2025, 2024, 2023, 2022, 2021, 2020, 2019, 2018, 2017, 2016, 2015. Other model years contribute to the overall range where sellers listed them without a year breakdown.

Which Dodge Durango drive shaft years are interchangeable?

Salvage-yard interchange data links Dodge Durango drive shaft fitments across 2011, 2012, 2013, 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2023, 2024, 2025. Searching all 15 years widens the pool of units; confirm the part number against your VIN, since trim or drivetrain can split an interchange group.

Used Dodge Durango Drive Shaft Cost — From $61 to $975