GMC Acadia drive shaft price snapshot
- Low
- $50
- Average
- $197
- High
- $549

Vehicle-specific price guide
A used GMC Acadia drive shaft costs $50 to $549, with a median asking price of $174. Based on 228 priced salvage yard listings across the US, compatible across 2012–2025 (14 model years), updated Sep 12, 2026. Prices exclude shipping, core charges, and installation.
Condition comparison
| Grade | Price range | Relative range | Listings |
|---|---|---|---|
| Grade AClean / low wear | $61–$549 | 178 | |
| Grade BStandard used | $61–$316 | 32 | |
| Grade CVisible wear | Updating | — | |
| Grade XUngraded | $50–$200 | 18 |
Median by grade
Median asking price by seller-reported condition grade · $50–$549 overall range
Replacement cost
Labor is a typical independent-shop range for drive shaft replacement, not a quote for your vehicle. The part price is the live median from the salvage-yard listings on this page. Full drive shaft replacement cost breakdown
Model-year comparison
Market analysis
The going rate for a used GMC Acadia drive shaft is $174 at the median, with listings spanning $50 to $549. That figure comes from 228 priced salvage-yard listings tracked by our index. Condition matters: grade-A units (lowest mileage, best condition) carry roughly a 64% premium over grade-B stock, with grade-A medians at $174.
Fitment variant moves the price more than most buyers expect. The most affordable variant we track, VIN Z (11th digit), lists at a $126 median, while VIN J (11th digit, Limited) commands $127, a 1% gap inside the same part category. Confirm which variant your VIN requires before comparing quotes.
Model year matters too: 2022 units carry the lowest median at $115, while 2024 tops the table at $430. Parts from 2017–2025 are interchangeable, so if the 2022 fits your vehicle, it offers the best value across 9 compatible years.
Against comparable vehicles, the GMC Acadia sits 30% below the GMC Sierra 1500 ($248), 8% below the Ram 1500 ($190), and 28% below the Ford F150 ($243) for the same part. The “similar vehicles” cards below open each comparison guide.
Keep browsing this vehicle


























Price data updating







Price data updating






Price data updating















Price comparisons
Compare fitments
Common questions
Based on 228 priced salvage yard listings, a used GMC Acadia drive shaft lists between $50 and $549, with a median asking price of $174.
Using a used part, a GMC Acadia drive shaft replacement typically runs $270–$625 all-in: the median used drive shaft for this model lists at $174, and independent-shop labor for drive shaft replacement typically takes 1–3 hours at $95–$150/hr ($95–$450). Labor is a national part-level estimate, not a quote for your vehicle.
Condition grade, mileage, model year, and fitment variant all move the price. Our data covers 2 distinct trims/variants for this part. Check the variant table above, since interchange differences can change the price substantially. Always confirm fitment against your VIN or part number before buying.
This guide currently has year-level pricing for 2024, 2022, 2018, 2017, 2016, 2015. Other model years contribute to the overall range where sellers listed them without a year breakdown.
Based on salvage-yard interchange data, GMC Acadia drive shaft listings appear across model years 2012, 2013, 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2023, 2024, 2025, suggesting these years share compatible fitments. Shopping across all 14 years may surface better prices or grades. Always verify the exact part number and VIN before buying — interchange compatibility can vary by trim or drivetrain.
A driveshaft is another name for a drive shaft. The GMC Acadia drive shaft prices on this page apply — median $174, from 228 salvage yard listings.