Used Infiniti QX60 drive shaft from a salvage yard

Vehicle-specific price guide

How much is a used Infiniti QX60 drive shaft?

Asking prices from 66 salvage yards in 11 states, broken down by model year, condition grade, and fitment variant.
SKWritten bySaurabh Kumar · Co-Founder & CTO
ASReviewed byAmbika Sharma · Co-Founder & COO
Last updatedOct 17, 2026
Strong coverage395 priced of 452 observed2 variantsMethodology v2.1 →

Part overview

About the Infiniti QX60 drive shaft

What the drive shaft does, common failure signs, and prices across all vehicles: used drive shaft price guide →

Also known asDriveshaftPropeller ShaftProp Shaft
Price summary

A used Infiniti QX60 drive shaft costs $50 to $568, with a median asking price of $174. Based on 395 priced salvage yard listings across the US, compatible across 2013–2025 (12 model years), updated Oct 17, 2026. Prices exclude shipping, core charges, and installation.

Grade A (excellent)$150
Grade B (good)$189

Infiniti QX60 drive shaft price snapshot

USD
Low
$50
Average
$205
High
$568
452 listings observed · 395 priced12d ago· How we price·

Report incorrect price

Reporting price for Infiniti QX60 Drive Shaft

Reason

Condition comparison

Price by part grade

Grade AClean / low wear$50–$558277 listings
Grade BStandard used$68–$568112 listings
Grade XUngraded$100–$4506 listings

Median by grade

Grade price comparison

Median asking price by seller-reported condition grade · $50–$568 overall range

Regional supply

Where the Infiniti QX60 drive shaft is listed

We found priced Infiniti QX60 drive shaft listings at 66 salvage yards across 11 states. Illinois supplies the most, with 185 listings (47% of the total) from 12 yards. Location matters: yards in California ask a median $100, while South Carolina yards ask $485, 385% more for the same part. Shipping usually costs less than that gap for smaller parts, so it can pay to buy out of state.

StateListingsYardsMedian ask
Illinois18512$125-28%
Florida6312$395+127%
Texas424$201+16%
California4217$100-43%
Wisconsin196$158-9%
South Carolina121$485+179%
Georgia116$145-17%
Indiana104$207+19%

States with at least 10 priced listings. % is versus the $174 national median.

Replacement cost

What is the Infiniti QX60 drive shaft replacement cost?

ESTIMATE
Used part
$174
Infiniti QX60 median asking price
Labor
$95–$450
1–3 hours at $95–$150/hr
Estimated total
$270–$625
median used part + labor

Labor is a typical independent-shop range for drive shaft replacement, not a quote for your vehicle. The part price is the live median from the salvage-yard listings on this page. Full drive shaft replacement cost breakdown

Sources
  1. Labor time estimates: Part Price Guide labor database

Set price alert

Alert for Infiniti QX60 Drive Shaft

$

Current avg: $205 — we suggest $174 (15% below)

Condition grade (optional)

Fitment matters

Price by trim & variant (2025)

Model-year comparison

What does a Infiniti QX60 drive shaft cost by year?

$89$188$288$387$4862015201620172018201920202022202320242025
Median asking price by model year · salvage yard listing data

Market analysis

How much does a used Infiniti QX60 drive shaft cost?

Asking prices for a used Infiniti QX60 drive shaft are unusually spread out: the top listing asks more than ten times what the cheapest does, so which unit you pick matters more than the median.

Model year matters too: 2018 units carry the lowest median at $99, while 2025 tops the table at $463. Parts from 2013–2020 are interchangeable, so if the 2018 fits your vehicle, it offers the best value across 8 compatible years.

Against comparable vehicles, the Infiniti QX60 sits 8% below the Ram 1500 ($190), 24% below the Chevy Silverado 1500 ($228), and 28% below the GMC Sierra 1500 ($243) for the same part. The “similar vehicles” cards below open each comparison guide.

Buying a used drive shaft: what to check

  1. Flex universal joints and CV boots: Articulate each U-joint by hand to check for stiff binding, rusted needle bearings, or torn rubber constant-velocity boots.
  2. Inspect slip yoke splines and balance weights: Check male splines for twisting or galling, and verify that welded steel balance weights are present along the tube.
  3. Examine center carrier bearing rubber: Inspect two-piece driveshaft center bearings for cracked rubber mounting rings or noisy, dry support bearings.
  4. Measure overall compressed length: Verify flange-to-flange operating length exactly, as transmission options and wheelbase variations alter shaft dimensions.
  5. Index flange alignment before installation: Mark mating yokes to the differential flange before installation to prevent high-speed driveline vibration.

Keep browsing this vehicle

What other Infiniti QX60 parts are priced?

Price comparisons

Compare Infiniti QX60 drive shaft prices

Compare fitments

What do similar vehicles charge for this part?

Common questions

Infiniti QX60 drive shaft FAQ

How much is a used drive shaft for a Infiniti QX60?

The median asking price is $174 across 395 priced listings from 66 yards. Grade-A units, the cleanest stock, have a median of $150. 2018 is the cheapest model year we track, with a median of $99.

How much does it cost to replace a Infiniti QX60 drive shaft?

Using a used part, a Infiniti QX60 drive shaft replacement typically runs $270–$625 all-in: the median used drive shaft for this model lists at $174, and independent-shop labor for drive shaft replacement typically takes 1–3 hours at $95–$150/hr ($95–$450). Labor is a national part-level estimate, not a quote for your vehicle.

Which Infiniti QX60 model years does this price guide cover?

This guide currently has year-level pricing for 2025, 2024, 2023, 2022, 2020, 2019, 2018, 2017, 2016, 2015. Other model years contribute to the overall range where sellers listed them without a year breakdown.

Which Infiniti QX60 drive shaft years are interchangeable?

Salvage-yard interchange data links Infiniti QX60 drive shaft fitments across 2013, 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2022, 2023, 2024, 2025. Searching all 12 years widens the pool of units; confirm the part number against your VIN, since trim or drivetrain can split an interchange group.

Used Infiniti QX60 Drive Shaft Cost — From $50 to $568