Toyota Corolla drive shaft price snapshot
- Low
- $50
- Average
- $332
- High
- $1,530

Vehicle-specific price guide
A used Toyota Corolla drive shaft costs $50 to $1,530, with a median asking price of $294. Based on 1,425 priced salvage yard listings across the US, compatible across 2014–2025 (12 model years), updated Sep 13, 2026. Prices exclude shipping, core charges, and installation.
Condition comparison
| Grade | Price range | Relative range | Listings |
|---|---|---|---|
| Grade AClean / low wear | $50–$1,530 | 799 | |
| Grade BStandard used | $71–$699 | 552 | |
| Grade CVisible wear | $200–$419 | 3 | |
| Grade XUngraded | $90–$1,068 | 71 |
Median by grade
Median asking price by seller-reported condition grade · $50–$1,530 overall range
Replacement cost
Labor is a typical independent-shop range for drive shaft replacement, not a quote for your vehicle. The part price is the live median from the salvage-yard listings on this page. Full drive shaft replacement cost breakdown
Model-year comparison
Market analysis
The going rate for a used Toyota Corolla drive shaft is $294 at the median, with listings spanning $50 to $1,530. That figure comes from 1,425 priced salvage-yard listings tracked by our index.
Fitment variant moves the price more than most buyers expect. The most affordable variant we track, 145.0" WB, 2.7L (turbo), 4x2, 8.8" rear axle, lists at a $172 median, while 145.0" WB, 5.0L, 4x2, 9.75" rear axle commands $584, a 240% gap inside the same part category. Confirm which variant your VIN requires before comparing quotes.
Model year matters too: 2021 units carry the lowest median at $158, while 2020 tops the table at $495. Parts from 2020–2025 are interchangeable, so if the 2021 fits your vehicle, it offers the best value across 5 compatible years.
Against comparable vehicles, the Toyota Corolla sits 19% above the GMC Sierra 1500 ($248), 55% above the Ram 1500 ($190), and 21% above the Ford F150 ($243) for the same part. The “similar vehicles” cards below open each comparison guide.
Keep browsing this vehicle


























Price data updating




























Price comparisons
Compare fitments
Price data updating
Common questions
Based on 1,425 priced salvage yard listings, a used Toyota Corolla drive shaft lists between $50 and $1,530, with a median asking price of $294.
Using a used part, a Toyota Corolla drive shaft replacement typically runs $390–$745 all-in: the median used drive shaft for this model lists at $294, and independent-shop labor for drive shaft replacement typically takes 1–3 hours at $95–$150/hr ($95–$450). Labor is a national part-level estimate, not a quote for your vehicle.
Condition grade, mileage, model year, and fitment variant all move the price. Our data covers 45 distinct trims/variants for this part. Check the variant table above, since interchange differences can change the price substantially. Always confirm fitment against your VIN or part number before buying.
This guide currently has year-level pricing for 2024, 2023, 2022, 2021, 2020, 2019, 2018, 2017, 2016. Other model years contribute to the overall range where sellers listed them without a year breakdown.
Based on salvage-yard interchange data, Toyota Corolla drive shaft listings appear across model years 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2023, 2024, 2025, suggesting these years share compatible fitments. Shopping across all 12 years may surface better prices or grades. Always verify the exact part number and VIN before buying — interchange compatibility can vary by trim or drivetrain.
A driveshaft is another name for a drive shaft. The Toyota Corolla drive shaft prices on this page apply — median $294, from 1,425 salvage yard listings.