Used Mazda 3 engine computer from a salvage yard

Vehicle-specific price guide

How much is a used Mazda 3 engine computer?

Asking prices from 559 salvage yards in 47 states, broken down by model year, condition grade, and fitment variant.
SKWritten bySaurabh Kumar · Co-Founder & CTO
ASReviewed byAmbika Sharma · Co-Founder & COO
Last updatedOct 22, 2026
Strong coverage1,926 priced of 2,314 observed2 variantsMethodology v2.1 →

Part overview

About the Mazda 3 engine computer

What the engine computer does, common failure signs, and prices across all vehicles: used engine computer price guide →

Also known asECUECMPCMEngine Control ModuleEngine Control UnitPowertrain Control Module
Price summary

A used Mazda 3 engine computer costs $25 to $465, with a median asking price of $101. Based on 1,926 priced salvage yard listings across the US, compatible across 2014–2025 (12 model years), updated Oct 22, 2026. Prices exclude shipping, core charges, and installation.

Grade A (excellent)$104
Grade B (good)$110
Grade C (fair)$100

Mazda 3 engine computer price snapshot

USD
Low
$25
Average
$127
High
$465
2,314 listings observed · 1,926 priced9d ago· How we price·

Report incorrect price

Reporting price for Mazda 3 Engine Computer

Reason

Condition comparison

Price by part grade

Grade AClean / low wear$25–$4651,588 listings
Grade BStandard used$30–$465155 listings
Grade CVisible wear$99–$1257 listings
Grade XUngraded$30–$208176 listings

Median by grade

Grade price comparison

Median asking price by seller-reported condition grade · $25–$465 overall range

Regional supply

Where the Mazda 3 engine computer is listed

We found priced Mazda 3 engine computer listings at 559 salvage yards across 47 states. California supplies the most, with 512 listings (21% of the total) from 53 yards. Location matters: yards in California ask a median $75, while Michigan yards ask $190, 153% more for the same part. Shipping usually costs less than that gap for smaller parts, so it can pay to buy out of state.

StateListingsYardsMedian ask
California51253$75-26%
Texas44259$95-6%
Illinois13421$165+63%
Ohio9922$125+24%
Michigan8328$190+88%
Wisconsin7813$159+57%
Florida7228$101
Indiana7215$99-2%

States with at least 10 priced listings. % is versus the $101 national median.

Replacement cost

What is the Mazda 3 engine computer replacement cost?

ESTIMATE
Used part
$101
Mazda 3 median asking price
Labor
$95–$450
1–3 hours at $95–$150/hr
Estimated total
$195–$550
median used part + labor

Labor is a typical independent-shop range for engine computer replacement, not a quote for your vehicle; it does not include programming and key relearn procedure. The part price is the live median from the salvage-yard listings on this page. Full engine computer replacement cost breakdown

Sources
  1. Labor time estimates: Part Price Guide labor database

Set price alert

Alert for Mazda 3 Engine Computer

$

Current avg: $127 — we suggest $108 (15% below)

Condition grade (optional)

Fitment matters

Price by trim & variant (2025)

Model-year comparison

What does a Mazda 3 engine computer cost by year?

$77$111$145$178$21220152016201720182019202020212022202320242025
Median asking price by model year · salvage yard listing data

Market analysis

How much does a used Mazda 3 engine computer cost?

Asking prices for a used Mazda 3 engine computer are unusually spread out: the top listing asks more than ten times what the cheapest does, so which unit you pick matters more than the median. Condition matters: grade-A units (lowest mileage, best condition) carry roughly a 4% premium over grade-C stock, with grade-A medians at $104.

Model year matters too: 2018 units carry the lowest median at $86, while 2024 tops the table at $202. Parts from 2016–2018 are interchangeable, so if the 2018 fits your vehicle, it offers the best value across 3 compatible years.

Against comparable vehicles, the Mazda 3 sits 10% below the Honda Accord ($112), 9% below the Honda Civic ($111), and 20% below the Hyundai Elantra ($126) for the same part. The “similar vehicles” cards below open each comparison guide.

Buying a used engine computer: what to check

  1. Match hardware and service numbers: Ensure hardware revision codes and circuit board part numbers match exactly, as pinouts change mid-model year.
  2. Inspect multi-pin connector headers: Check header pins for bending, green copper oxidation, or burnt circuit board traces inside the wiring sockets.
  3. Verify immobilizer programming requirements: Plan for anti-theft security relearn procedures or ECU re-flashing before the replacement computer will start the engine.
  4. Confirm donor transmission and emissions spec: Ensure the donor vehicle used the same transmission type and regional emissions package to prevent fault codes.
  5. Check aluminum casing seals: Inspect housing screws and perimeter rubber gaskets for white oxidation or breaks that indicate past water intrusion.

Keep browsing this vehicle

What other Mazda 3 parts are priced?

Price comparisons

Compare Mazda 3 engine computer prices

Compare fitments

What do similar vehicles charge for this part?

Common questions

Mazda 3 engine computer FAQ

How much is a used engine computer for a Mazda 3?

The median asking price is $101 across 1,926 priced listings from 559 yards. Grade-A units, the cleanest stock, have a median of $104. 2018 is the cheapest model year we track, with a median of $86.

How much does it cost to replace a Mazda 3 engine computer?

Using a used part, a Mazda 3 engine computer replacement typically runs $195–$550 all-in: the median used engine computer for this model lists at $101, and independent-shop labor for engine computer replacement typically takes 1–3 hours at $95–$150/hr ($95–$450). The labor figure does not include programming and key relearn procedure. Labor is a national part-level estimate, not a quote for your vehicle.

Which Mazda 3 model years does this price guide cover?

This guide currently has year-level pricing for 2025, 2024, 2023, 2022, 2021, 2020, 2019, 2018, 2017, 2016, 2015. Other model years contribute to the overall range where sellers listed them without a year breakdown.

Which Mazda 3 engine computer years are interchangeable?

Salvage-yard interchange data links Mazda 3 engine computer fitments across 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2023, 2024, 2025. Searching all 12 years widens the pool of units; confirm the part number against your VIN, since trim or drivetrain can split an interchange group.

Used Mazda 3 Engine Computer Cost — From $25 to $465