Used Mazda 3 axle shaft from a salvage yard

Vehicle-specific price guide

How much is a used Mazda 3 axle shaft?

Asking prices from 582 salvage yards in 45 states, broken down by model year, condition grade, and fitment variant.
SKWritten bySaurabh Kumar · Co-Founder & CTO
ASReviewed byAmbika Sharma · Co-Founder & COO
Last updatedOct 31, 2026
Strong coverage3,340 priced of 3,815 observed2 variantsMethodology v2.1 →

Part overview

About the Mazda 3 axle shaft

What the axle shaft does, common failure signs, and prices across all vehicles: used axle shaft price guide →

Also known asCV AxleCV ShaftDrive AxleHalf ShaftAxle AssemblyCovers front CV axles and rear axle shafts.
Price summary

A used Mazda 3 axle shaft costs $28 to $424, with a median asking price of $96. Based on 3,340 priced salvage yard listings across the US, compatible across 2014–2025 (12 model years), updated Oct 31, 2026. Prices exclude shipping, core charges, and installation.

Grade A (excellent)$100
Grade B (good)$100
Grade C (fair)$75

Mazda 3 axle shaft price snapshot

USD
Low
$28
Average
$122
High
$424
3,815 listings observed · 3,340 pricedUpdated 18h ago· How we price·

Report incorrect price

Reporting price for Mazda 3 Axle Shaft

Reason

Condition comparison

Price by part grade

Grade AClean / low wear$28–$4242,635 listings
Grade BStandard used$30–$344522 listings
Grade CVisible wear$60–$9011 listings
Grade XUngraded$29–$274172 listings

Median by grade

Grade price comparison

Median asking price by seller-reported condition grade · $28–$424 overall range

Regional supply

Where the Mazda 3 axle shaft is listed

We found priced Mazda 3 axle shaft listings at 582 salvage yards across 45 states. California supplies the most, with 736 listings (16% of the total) from 51 yards. Location matters: yards in California ask a median $75, while Michigan yards ask $180, 140% more for the same part. Shipping usually costs less than that gap for smaller parts, so it can pay to buy out of state.

StateListingsYardsMedian ask
California73651$75-22%
Texas60747$94-2%
Arizona31716$82-15%
Michigan21333$180+88%
Illinois16625$121+26%
Florida13520$125+30%
New York13229$119+24%
Ohio12118$137+43%

States with at least 10 priced listings. % is versus the $96 national median.

Replacement cost

What is the Mazda 3 axle shaft replacement cost?

ESTIMATE
Used part
$96
Mazda 3 median asking price
Labor
$95–$375
1–2.5 hours at $95–$150/hr
Estimated total
$190–$470
median used part + labor

Labor is a typical independent-shop range for axle shaft replacement, not a quote for your vehicle. The part price is the live median from the salvage-yard listings on this page. How we price

Sources
  1. Labor time estimates: Part Price Guide labor database

Set price alert

Alert for Mazda 3 Axle Shaft

$

Current avg: $122 — we suggest $104 (15% below)

Condition grade (optional)

Fitment matters

Price by trim & variant (2026)

front axle50 listingsInterchange 2019–2023$74$45 – $321
rear axle49 listingsInterchange 2018–2025$247$50 – $343

Model-year comparison

What does a Mazda 3 axle shaft cost by year?

$55$89$123$157$191201520162017201820192020202120222023202420252026
Median asking price by model year · salvage yard listing data

Market analysis

How much does a used Mazda 3 axle shaft cost?

Asking prices for a used Mazda 3 axle shaft are unusually spread out: the top listing asks more than ten times what the cheapest does, so which unit you pick matters more than the median. Condition matters: grade-A units (lowest mileage, best condition) carry roughly a 33% premium over grade-C stock, with grade-A medians at $100.

Fitment variant moves the price more than most buyers expect. The most affordable variant we track, front axle, lists at a $74 median, while rear axle commands $247, a 234% gap inside the same part category. Confirm which variant your VIN requires before comparing quotes.

Model year matters too: 2017 units carry the lowest median at $61, while 2024 tops the table at $182. Parts from 2014–2018 are interchangeable, so if the 2017 fits your vehicle, it offers the best value across 5 compatible years.

Against comparable vehicles, the Mazda 3 sits 67% below the Mercedes GLE Class ($287), 52% below the Mercedes C Class ($202), and 54% below the Mercedes E Class ($209) for the same part. The “similar vehicles” cards below open each comparison guide.

Buying a used axle shaft: what to check

  1. Inspect CV boots for cracks. A torn boot means the joint has likely ingested grit.
  2. Confirm ABS ring compatibility with your sensor setup.
  3. Left and right shafts usually differ in length, so verify the side.
  4. Spin the joints through full articulation and listen for clicking.

Keep browsing this vehicle

What other Mazda 3 parts are priced?

Price comparisons

Compare Mazda 3 axle shaft prices

Compare fitments

What do similar vehicles charge for this part?

Common questions

Mazda 3 axle shaft FAQ

How much is a used axle shaft for a Mazda 3?

The median asking price is $96 across 3,340 priced listings from 582 yards. Grade-A units, the cleanest stock, have a median of $100. 2017 is the cheapest model year we track, with a median of $61.

How much does it cost to replace a Mazda 3 axle shaft?

Using a used part, a Mazda 3 axle shaft replacement typically runs $190–$470 all-in: the median used axle shaft for this model lists at $96, and independent-shop labor for axle shaft replacement typically takes 1–2.5 hours at $95–$150/hr ($95–$375). Labor is a national part-level estimate, not a quote for your vehicle.

Which Mazda 3 model years does this price guide cover?

This guide currently has year-level pricing for 2026, 2025, 2024, 2023, 2022, 2021, 2020, 2019, 2018, 2017, 2016, 2015. Other model years contribute to the overall range where sellers listed them without a year breakdown.

Which Mazda 3 axle shaft years are interchangeable?

Salvage-yard interchange data links Mazda 3 axle shaft fitments across 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2023, 2024, 2025. Searching all 12 years widens the pool of units; confirm the part number against your VIN, since trim or drivetrain can split an interchange group.

Used Mazda 3 Axle Shaft Cost — From $28 to $424