Used Mazda 3 starter from a salvage yard

Vehicle-specific price guide

How much is a used Mazda 3 starter?

Asking prices from 366 salvage yards in 46 states, broken down by model year, condition grade, and fitment variant.
SKWritten bySaurabh Kumar · Co-Founder & CTO
ASReviewed byAmbika Sharma · Co-Founder & COO
Last updatedNov 1, 2026
Strong coverage753 priced of 1,096 observed2 variantsMethodology v2.1 →

Part overview

About the Mazda 3 starter

What the starter does, common failure signs, and prices across all vehicles: used starter price guide →

Also known asStarter Motor
Price summary

A used Mazda 3 starter costs $25 to $385, with a median asking price of $71. Based on 753 priced salvage yard listings across the US, compatible across 2012–2025 (14 model years), updated Nov 1, 2026. Prices exclude shipping, core charges, and installation.

Grade A (excellent)$75
Grade B (good)$55
Grade C (fair)$45

Mazda 3 starter price snapshot

USD
Low
$25
Average
$93
High
$385
1,096 listings observed · 753 pricedUpdated 3h ago· How we price·

Report incorrect price

Reporting price for Mazda 3 Starter

Reason

Condition comparison

Price by part grade

Grade AClean / low wear$25–$385590 listings
Grade BStandard used$32–$16447 listings
Grade CVisible wear$35–$10012 listings
Grade XUngraded$25–$100104 listings

Median by grade

Grade price comparison

Median asking price by seller-reported condition grade · $25–$385 overall range

Regional supply

Where the Mazda 3 starter is listed

We found priced Mazda 3 starter listings at 366 salvage yards across 46 states. Illinois supplies the most, with 255 listings (15% of the total) from 22 yards. Location matters: yards in California ask a median $50, while Florida yards ask $85, 70% more for the same part. Shipping usually costs less than that gap for smaller parts, so it can pay to buy out of state.

StateListingsYardsMedian ask
Illinois25522$55-23%
California15332$50-30%
Texas14127$65-8%
Pennsylvania13422$66-7%
Arizona13319$60-15%
Florida9521$85+20%
New York5618$56-21%
Indiana468$84+18%

States with at least 10 priced listings. % is versus the $71 national median.

Replacement cost

What is the Mazda 3 starter replacement cost?

ESTIMATE
Used part
$71
Mazda 3 median asking price
Labor
$95–$450
1–3 hours at $95–$150/hr
Estimated total
$165–$520
median used part + labor

Labor is a typical independent-shop range for starter replacement, not a quote for your vehicle. The part price is the live median from the salvage-yard listings on this page. Full starter replacement cost breakdown

Sources
  1. Labor time estimates: Part Price Guide labor database

Set price alert

Alert for Mazda 3 Starter

$

Current avg: $93 — we suggest $79 (15% below)

Condition grade (optional)

Fitment matters

Price by trim & variant (2025)

Model-year comparison

What does a Mazda 3 starter cost by year?

$45$60$76$91$10620152016201720182019202020212022202320242025
Median asking price by model year · salvage yard listing data

Market analysis

How much does a used Mazda 3 starter cost?

Asking prices for a used Mazda 3 starter are unusually spread out: the top listing asks more than ten times what the cheapest does, so which unit you pick matters more than the median. Condition matters: grade-A units (lowest mileage, best condition) carry roughly a 67% premium over grade-C stock, with grade-A medians at $75.

Fitment variant moves the price more than most buyers expect. The most affordable variant we track, Non-Interchange search using only Mazda 3, lists at a $55 median, while Non-Interchange search using Mazda 3 and similar models commands $100, a 82% gap inside the same part category. Confirm which variant your VIN requires before comparing quotes.

Model year matters too: 2017 units carry the lowest median at $50, while 2021 tops the table at $101. Parts from 2012–2023 are interchangeable, so if the 2017 fits your vehicle, it offers the best value across 11 compatible years.

Against comparable vehicles, the Mazda 3 sits 44% below the Ford F150 ($126), 36% below the Mercedes E Class ($111), and 43% below the Mercedes S Class ($125) for the same part. The “similar vehicles” cards below open each comparison guide.

Buying a used starter: what to check

  1. Ask if the unit was bench-tested. Starters are cheap to test and yards that do will say so.
  2. Match the flywheel tooth count and mounting bolt pattern to your engine code.
  3. Check the solenoid connector style; mid-year changes are common.
  4. A remanufactured unit with warranty is sometimes only slightly more than used, so compare both.

Keep browsing this vehicle

What other Mazda 3 parts are priced?

Price comparisons

Compare Mazda 3 starter prices

Compare fitments

What do similar vehicles charge for this part?

Common questions

Mazda 3 starter FAQ

How much is a used starter for a Mazda 3?

The median asking price is $71 across 753 priced listings from 366 yards. Grade-A units, the cleanest stock, have a median of $75. 2017 is the cheapest model year we track, with a median of $50.

How much does it cost to replace a Mazda 3 starter?

Using a used part, a Mazda 3 starter replacement typically runs $165–$520 all-in: the median used starter for this model lists at $71, and independent-shop labor for starter replacement typically takes 1–3 hours at $95–$150/hr ($95–$450). Labor is a national part-level estimate, not a quote for your vehicle.

Which Mazda 3 model years does this price guide cover?

This guide currently has year-level pricing for 2025, 2024, 2023, 2022, 2021, 2020, 2019, 2018, 2017, 2016, 2015. Other model years contribute to the overall range where sellers listed them without a year breakdown.

Which Mazda 3 starter years are interchangeable?

Salvage-yard interchange data links Mazda 3 starter fitments across 2012, 2013, 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2023, 2024, 2025. Searching all 14 years widens the pool of units; confirm the part number against your VIN, since trim or drivetrain can split an interchange group.

Used Mazda 3 Starter Cost — From $25 to $385