Used Jeep Wrangler ignition switch from a salvage yard

Vehicle-specific price guide

How much is a used Jeep Wrangler ignition switch?

Asking prices from 105 salvage yards in 27 states, broken down by model year, condition grade, and fitment variant.
SKWritten bySaurabh Kumar · Co-Founder & CTO
ASReviewed byAmbika Sharma · Co-Founder & COO
Last updatedOct 22, 2026
Strong coverage356 priced of 595 observed2 variantsMethodology v2.1 →

Part overview

About the Jeep Wrangler ignition switch

What the ignition switch does, common failure signs, and prices across all vehicles: used ignition switch price guide →

Also known asKey SwitchIgnition Starter Switch
Price summary

A used Jeep Wrangler ignition switch costs $55 to $137, with a median asking price of $78. Based on 356 priced salvage yard listings across the US, compatible across 2007–2025 (19 model years), updated Oct 22, 2026. Prices exclude shipping, core charges, and installation.

Grade A (excellent)$78
Grade B (good)$78

Jeep Wrangler ignition switch price snapshot

USD
Low
$55
Average
$87
High
$137
595 listings observed · 356 priced10d ago· How we price·

Report incorrect price

Reporting price for Jeep Wrangler Ignition Switch

Reason

Condition comparison

Price by part grade

Grade AClean / low wear$55–$137273 listings
Grade BStandard used$78–$13762 listings
Grade XUngraded$65–$12521 listings

Median by grade

Grade price comparison

Median asking price by seller-reported condition grade · $55–$137 overall range

Regional supply

Where the Jeep Wrangler ignition switch is listed

We found priced Jeep Wrangler ignition switch listings at 105 salvage yards across 27 states. California supplies the most, with 160 listings (21% of the total) from 16 yards. Location matters: yards in Michigan ask a median $25, while Illinois yards ask $109, 336% more for the same part. Shipping usually costs less than that gap for smaller parts, so it can pay to buy out of state.

StateListingsYardsMedian ask
California16016$78
Texas7212$78
New York665$99+27%
Michigan645$25-68%
Florida638$78
Illinois428$109+40%
Arizona394$78
Oklahoma281$78

States with at least 10 priced listings. % is versus the $78 national median.

Replacement cost

What is the Jeep Wrangler ignition switch replacement cost?

ESTIMATE
Used part
$78
Jeep Wrangler median asking price
Labor
$95–$375
1–2.5 hours at $95–$150/hr
Estimated total
$175–$455
median used part + labor

Labor is a typical independent-shop range for ignition switch replacement, not a quote for your vehicle; it does not include key programming if the vehicle has an immobilizer system. The part price is the live median from the salvage-yard listings on this page. Full ignition switch replacement cost breakdown

Sources
  1. Labor time estimates: Part Price Guide labor database

Set price alert

Alert for Jeep Wrangler Ignition Switch

$

Current avg: $87 — we suggest $74 (15% below)

Condition grade (optional)

Fitment matters

Price by trim & variant (2018)

(LHD), VIN X (6th digit, JL body), (keyless ignition, push button start)35 listingsInterchange 2018–2025$78$55 – $116

(LHD), VIN W (6th digit, JK body)

2 listings
Interchange 2007–2016$66$66 – $66

Model-year comparison

What does a Jeep Wrangler ignition switch cost by year?

$59$71$82$94$10520152016201720182019202020212022202320242025
Median asking price by model year · salvage yard listing data

Market analysis

How much does a used Jeep Wrangler ignition switch cost?

Asking prices for a used Jeep Wrangler ignition switch sit in a fairly tight band around the $78 median, so most quotes far outside it deserve a second look.

Fitment variant moves the price more than most buyers expect. The most affordable variant we track, (LHD), VIN W (6th digit, JK body), lists at a $66 median, while (LHD), VIN X (6th digit, JL body), (keyless ignition, push button start) commands $78, a 18% gap inside the same part category. Confirm which variant your VIN requires before comparing quotes.

Model year matters too: 2017 units carry the lowest median at $66, while 2015 tops the table at $100. Parts from 2007–2016 are interchangeable, so if the 2017 fits your vehicle, it offers the best value across 10 compatible years.

Against comparable vehicles, the Jeep Wrangler sits 22% below the Mercedes S Class ($100), 22% below the Hyundai Elantra ($100), and 21% below the Mercedes GLE Class ($99) for the same part. The “similar vehicles” cards below open each comparison guide.

Buying a used ignition switch: what to check

  1. Inspect contact board for arc burning: Check multi-pin electrical harness plugs for brown heat discoloration caused by worn internal switch contacts.
  2. Test key cylinder detent feel: Turn the key through Accessory, Run, and Start positions to ensure crisp detents without key binding or slop.
  3. Verify immobilizer antenna halo inclusion: Confirm the plastic transponder receiver ring surrounds the key cylinder and has undamaged wiring terminals.
  4. Check mechanical steering lock bolt: Verify the spring-loaded column locking bolt extends and retracts smoothly when inserting and removing the key.
  5. Plan for key matching or re-keying: Ask if matching door keys are included, or budget for a lock technician to re-key the cylinder to your original key.

Keep browsing this vehicle

What other Jeep Wrangler parts are priced?

Price comparisons

Compare Jeep Wrangler ignition switch prices

Compare fitments

What do similar vehicles charge for this part?

Common questions

Jeep Wrangler ignition switch FAQ

How much is a used ignition switch for a Jeep Wrangler?

The median asking price is $78 across 356 priced listings from 105 yards. Grade-A units, the cleanest stock, have a median of $78. 2017 is the cheapest model year we track, with a median of $66.

How much does it cost to replace a Jeep Wrangler ignition switch?

Using a used part, a Jeep Wrangler ignition switch replacement typically runs $175–$455 all-in: the median used ignition switch for this model lists at $78, and independent-shop labor for ignition switch replacement typically takes 1–2.5 hours at $95–$150/hr ($95–$375). The labor figure does not include key programming if the vehicle has an immobilizer system. Labor is a national part-level estimate, not a quote for your vehicle.

Which Jeep Wrangler model years does this price guide cover?

This guide currently has year-level pricing for 2025, 2024, 2023, 2022, 2021, 2020, 2019, 2018, 2017, 2016, 2015. Other model years contribute to the overall range where sellers listed them without a year breakdown.

Which Jeep Wrangler ignition switch years are interchangeable?

Salvage-yard interchange data links Jeep Wrangler ignition switch fitments across 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2023, 2024, 2025. Searching all 19 years widens the pool of units; confirm the part number against your VIN, since trim or drivetrain can split an interchange group.

Used Jeep Wrangler Ignition Switch Cost — From $55 to $137