Used Jeep Wrangler water pump from a salvage yard

Vehicle-specific price guide

How much is a used Jeep Wrangler water pump?

Asking prices from 68 salvage yards in 23 states, broken down by model year, condition grade, and fitment variant.
SKWritten bySaurabh Kumar · Co-Founder & CTO
ASReviewed byAmbika Sharma · Co-Founder & COO
Last updatedOct 21, 2026
Strong coverage730 priced of 1,058 observed5 variantsMethodology v2.1 →

Part overview

About the Jeep Wrangler water pump

What the water pump does, common failure signs, and prices across all vehicles: used water pump price guide →

Also known asCoolant PumpEngine Water Pump
Price summary

A used Jeep Wrangler water pump costs $25 to $275, with a median asking price of $125. Based on 730 priced salvage yard listings across the US, compatible across 2012–2025 (14 model years), updated Oct 21, 2026. Prices exclude shipping, core charges, and installation.

Grade A (excellent)$145
Grade B (good)$200

Jeep Wrangler water pump price snapshot

USD
Low
$25
Average
$138
High
$275
1,058 listings observed · 730 priced11d ago· How we price·

Report incorrect price

Reporting price for Jeep Wrangler Water Pump

Reason

Condition comparison

Price by part grade

Grade AClean / low wear$25–$275419 listings
Grade BStandard used$60–$253219 listings
Grade XUngraded$29–$12992 listings

Median by grade

Grade price comparison

Median asking price by seller-reported condition grade · $25–$275 overall range

Regional supply

Where the Jeep Wrangler water pump is listed

We found priced Jeep Wrangler water pump listings at 68 salvage yards across 23 states. Florida supplies the most, with 154 listings (21% of the total) from 7 yards. Location matters: yards in Indiana ask a median $60, while Florida yards ask $224, 273% more for the same part. Shipping usually costs less than that gap for smaller parts, so it can pay to buy out of state.

StateListingsYardsMedian ask
Florida1547$224+79%
Indiana814$60-52%
New Jersey742$89-29%
Georgia683$124-1%
California6610$150+20%
Michigan566$100-20%
South Carolina315$100-20%
Texas283$178+42%

States with at least 10 priced listings. % is versus the $125 national median.

Replacement cost

What is the Jeep Wrangler water pump replacement cost?

ESTIMATE
Used part
$125
Jeep Wrangler median asking price
Labor
$190–$750
2–5 hours at $95–$150/hr
Estimated total
$315–$875
median used part + labor

Labor is a typical independent-shop range for water pump replacement, not a quote for your vehicle; it does not include coolant refill and system bleed; timing belt replacement recommended if belt-driven. The part price is the live median from the salvage-yard listings on this page. Full water pump replacement cost breakdown

Sources
  1. Labor time estimates: Part Price Guide labor database

Set price alert

Alert for Jeep Wrangler Water Pump

$

Current avg: $138 — we suggest $117 (15% below)

Condition grade (optional)

Fitment matters

Price by trim & variant (2025)

engine, 2.0L, gasoline25 listingsInterchange 2018–2025$145$40 – $251
battery cooling, fuel cell stack, (2.0L)22 listingsInterchange 2018–2024$112$60 – $275
battery cooling, auxiliary, (2.0L)17 listingsInterchange 2021–2025$152$65 – $266
engine, 3.6L12 listingsInterchange 2019–2023$200$54 – $226
engine, 2.0L, plug-in hybrid2 listings$80$80 – $80

Model-year comparison

What does a Jeep Wrangler water pump cost by year?

$78$97$115$134$15220152016201720182019202020212022202320242025
Median asking price by model year · salvage yard listing data

Market analysis

How much does a used Jeep Wrangler water pump cost?

Asking prices for a used Jeep Wrangler water pump are unusually spread out: the top listing asks more than ten times what the cheapest does, so which unit you pick matters more than the median.

Fitment variant moves the price more than most buyers expect. The most affordable variant we track, engine, 2.0L, plug-in hybrid, lists at a $80 median, while engine, 3.6L commands $200, a 150% gap inside the same part category. Confirm which variant your VIN requires before comparing quotes.

Model year matters too: 2015 units carry the lowest median at $87, while 2019 tops the table at $145. Parts from 2012–2018 are interchangeable, so if the 2015 fits your vehicle, it offers the best value across 7 compatible years.

Against comparable vehicles, the Jeep Wrangler sits 17% below the Mercedes S Class ($150), 21% below the Mercedes GLE Class ($158), and 13% below the Mercedes E Class ($144) for the same part. The “similar vehicles” cards below open each comparison guide.

Buying a used water pump: what to check

  1. Inspect weep hole for coolant stain trails: Check the bottom housing weep hole for wet coolant leaks, green crust, or rust trails indicating shaft seal failure.
  2. Verify shaft bearing play and impeller rotation: Spin the pulley hub by hand to feel for gritty bearing movement, radial shaft wobble, or binding impellers.
  3. Check impeller blade material and condition: Inspect plastic or stamped metal impeller vanes for cavitation erosion, broken fins, or loose press-fit hubs.
  4. Confirm housing mounting flange flatness: Verify that aluminum mating flanges are free of deep gouges, corrosion pits, or cracked bolt holes.
  5. Install a new gasket and flush system coolant: Clean block mating surfaces thoroughly and refill with fresh manufacturer-approved coolant during installation.

Keep browsing this vehicle

What other Jeep Wrangler parts are priced?

Price comparisons

Compare Jeep Wrangler water pump prices

Compare fitments

What do similar vehicles charge for this part?

Common questions

Jeep Wrangler water pump FAQ

How much is a used water pump for a Jeep Wrangler?

The median asking price is $125 across 730 priced listings from 68 yards. Grade-A units, the cleanest stock, have a median of $145. 2017 is the cheapest model year we track, with a median of $87.

How much does it cost to replace a Jeep Wrangler water pump?

Using a used part, a Jeep Wrangler water pump replacement typically runs $315–$875 all-in: the median used water pump for this model lists at $125, and independent-shop labor for water pump replacement typically takes 2–5 hours at $95–$150/hr ($190–$750). The labor figure does not include coolant refill and system bleed; timing belt replacement recommended if belt-driven. Labor is a national part-level estimate, not a quote for your vehicle.

Which Jeep Wrangler model years does this price guide cover?

This guide currently has year-level pricing for 2025, 2024, 2023, 2022, 2021, 2020, 2019, 2018, 2017, 2016, 2015. Other model years contribute to the overall range where sellers listed them without a year breakdown.

Which Jeep Wrangler water pump years are interchangeable?

Salvage-yard interchange data links Jeep Wrangler water pump fitments across 2012, 2013, 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2023, 2024, 2025. Searching all 14 years widens the pool of units; confirm the part number against your VIN, since trim or drivetrain can split an interchange group.

Used Jeep Wrangler Water Pump Cost — From $25 to $275