Used Fiat 500 axle shaft from a salvage yard

Vehicle-specific price guide

How much is a used Fiat 500 axle shaft?

Asking prices from 559 salvage yards in 47 states, broken down by model year, condition grade, and fitment variant.
SKWritten bySaurabh Kumar · Co-Founder & CTO
ASReviewed byAmbika Sharma · Co-Founder & COO
Last updatedOct 29, 2026
Strong coverage900 priced of 1,306 observed2 variantsMethodology v2.1 →

Part overview

About the Fiat 500 axle shaft

What the axle shaft does, common failure signs, and prices across all vehicles: used axle shaft price guide →

Also known asCV AxleCV ShaftDrive AxleHalf ShaftAxle AssemblyCovers front CV axles and rear axle shafts.
Price summary

A used Fiat 500 axle shaft costs $29 to $285, with a median asking price of $75. Based on 900 priced salvage yard listings across the US, compatible across 2012–2025 (14 model years), updated Oct 29, 2026. Prices exclude shipping, core charges, and installation.

Grade A (excellent)$76
Grade B (good)$75
Grade C (fair)$75

Fiat 500 axle shaft price snapshot

USD
Low
$29
Average
$95
High
$285
1,306 listings observed · 900 pricedUpdated 10h ago· How we price·

Report incorrect price

Reporting price for Fiat 500 Axle Shaft

Reason

Condition comparison

Price by part grade

Grade AClean / low wear$29–$285773 listings
Grade BStandard used$35–$23046 listings
Grade CVisible wear$45–$9512 listings
Grade XUngraded$40–$11069 listings

Median by grade

Grade price comparison

Median asking price by seller-reported condition grade · $29–$285 overall range

Regional supply

Where the Fiat 500 axle shaft is listed

We found priced Fiat 500 axle shaft listings at 559 salvage yards across 47 states. Texas supplies the most, with 222 listings (7% of the total) from 37 yards. Location matters: yards in Texas ask a median $68, while Michigan yards ask $162, 138% more for the same part. Shipping usually costs less than that gap for smaller parts, so it can pay to buy out of state.

StateListingsYardsMedian ask
Texas22237$68-9%
Indiana17324$70-7%
California17124$71-5%
Illinois15317$75
Michigan13326$162+116%
Missouri12420$115+53%
Florida11530$75
Virginia9813$100+33%

States with at least 10 priced listings. % is versus the $75 national median.

Replacement cost

What is the Fiat 500 axle shaft replacement cost?

ESTIMATE
Used part
$75
Fiat 500 median asking price
Labor
$95–$375
1–2.5 hours at $95–$150/hr
Estimated total
$170–$450
median used part + labor

Labor is a typical independent-shop range for axle shaft replacement, not a quote for your vehicle. The part price is the live median from the salvage-yard listings on this page. How we price

Sources
  1. Labor time estimates: Part Price Guide labor database

Set price alert

Alert for Fiat 500 Axle Shaft

$

Current avg: $95 — we suggest $81 (15% below)

Condition grade (optional)

Fitment matters

Price by trim & variant (2025)

Model-year comparison

What does a Fiat 500 axle shaft cost by year?

$54$84$115$145$175201520162018202020212025
Median asking price by model year · salvage yard listing data

Market analysis

How much does a used Fiat 500 axle shaft cost?

Asking prices for a used Fiat 500 axle shaft are unusually spread out: the top listing asks about 10 times what the cheapest does, so which unit you pick matters more than the median. Condition matters: grade-A units (lowest mileage, best condition) carry roughly a 1% premium over grade-C stock, with grade-A medians at $76.

Model year matters too: 2018 units carry the lowest median at $60, while 2025 tops the table at $167. Year-level pages linked in the table above break each one down by grade and variant.

Against comparable vehicles, the Fiat 500 sits 74% below the Mercedes GLE Class ($287), 63% below the Mercedes C Class ($202), and 65% below the Mercedes E Class ($215) for the same part. The “similar vehicles” cards below open each comparison guide.

Buying a used axle shaft: what to check

  1. Inspect CV boots for cracks. A torn boot means the joint has likely ingested grit.
  2. Confirm ABS ring compatibility with your sensor setup.
  3. Left and right shafts usually differ in length, so verify the side.
  4. Spin the joints through full articulation and listen for clicking.

Keep browsing this vehicle

What other Fiat 500 parts are priced?

Price comparisons

Compare Fiat 500 axle shaft prices

Compare fitments

What do similar vehicles charge for this part?

Common questions

Fiat 500 axle shaft FAQ

How much is a used axle shaft for a Fiat 500?

The median asking price is $75 across 900 priced listings from 559 yards. Grade-A units, the cleanest stock, have a median of $76. 2018 is the cheapest model year we track, with a median of $60.

How much does it cost to replace a Fiat 500 axle shaft?

Using a used part, a Fiat 500 axle shaft replacement typically runs $170–$450 all-in: the median used axle shaft for this model lists at $75, and independent-shop labor for axle shaft replacement typically takes 1–2.5 hours at $95–$150/hr ($95–$375). Labor is a national part-level estimate, not a quote for your vehicle.

Which Fiat 500 model years does this price guide cover?

This guide currently has year-level pricing for 2025, 2024, 2023, 2021, 2020, 2018, 2016, 2015. Other model years contribute to the overall range where sellers listed them without a year breakdown.

Which Fiat 500 axle shaft years are interchangeable?

Salvage-yard interchange data links Fiat 500 axle shaft fitments across 2012, 2013, 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2023, 2024, 2025. Searching all 14 years widens the pool of units; confirm the part number against your VIN, since trim or drivetrain can split an interchange group.

Used Fiat 500 Axle Shaft Cost — From $29 to $285