Used Kia K5 drive shaft from a salvage yard

Vehicle-specific price guide

How much is a used Kia K5 drive shaft?

Asking prices from 161 salvage yards in 30 states, broken down by model year, condition grade, and fitment variant.
SKWritten bySaurabh Kumar · Co-Founder & CTO
ASReviewed byAmbika Sharma · Co-Founder & COO
Last updatedOct 27, 2026
Strong coverage173 priced of 182 observed0 variantsMethodology v2.1 →

Part overview

About the Kia K5 drive shaft

What the drive shaft does, common failure signs, and prices across all vehicles: used drive shaft price guide →

Also known asDriveshaftPropeller ShaftProp Shaft
Price summary

A used Kia K5 drive shaft costs $125 to $544, with a median asking price of $277. Based on 173 priced salvage yard listings across the US, compatible across 2021–2025 (5 model years), updated Oct 27, 2026. Prices exclude shipping, core charges, and installation.

Grade A (excellent)$257
Grade B (good)$304

Kia K5 drive shaft price snapshot

USD
Low
$125
Average
$281
High
$544
182 listings observed · 173 pricedUpdated 2d ago· How we price·

Report incorrect price

Reporting price for Kia K5 Drive Shaft

Reason

Condition comparison

Price by part grade

Grade AClean / low wear$125–$544106 listings
Grade BStandard used$167–$37867 listings

Median by grade

Grade price comparison

Median asking price by seller-reported condition grade · $125–$544 overall range

Regional supply

Where the Kia K5 drive shaft is listed

We found priced Kia K5 drive shaft listings at 161 salvage yards across 30 states. Michigan supplies the most, with 59 listings (10% of the total) from 14 yards. Location matters: yards in New York ask a median $145, while Wisconsin yards ask $292, 101% more for the same part. Shipping usually costs less than that gap for smaller parts, so it can pay to buy out of state.

StateListingsYardsMedian ask
Michigan5914$278
Wisconsin5212$292+5%
Illinois4912$262-5%
Ohio4212$187-32%
New York359$145-48%
Indiana309$223-19%
North Carolina287$171-38%
Florida286$171-38%

States with at least 10 priced listings. % is versus the $277 national median.

Replacement cost

What is the Kia K5 drive shaft replacement cost?

ESTIMATE
Used part
$277
Kia K5 median asking price
Labor
$95–$450
1–3 hours at $95–$150/hr
Estimated total
$370–$725
median used part + labor

Labor is a typical independent-shop range for drive shaft replacement, not a quote for your vehicle. The part price is the live median from the salvage-yard listings on this page. Full drive shaft replacement cost breakdown

Sources
  1. Labor time estimates: Part Price Guide labor database

Set price alert

Alert for Kia K5 Drive Shaft

$

Current avg: $281 — we suggest $239 (15% below)

Condition grade (optional)

Model-year comparison

What does a Kia K5 drive shaft cost by year?

$248$258$269$280$2912021202220232025
Median asking price by model year · salvage yard listing data

Market analysis

How much does a used Kia K5 drive shaft cost?

Asking prices for a used Kia K5 drive shaft are unusually spread out: the top listing asks about 4 times what the cheapest does, so which unit you pick matters more than the median.

Model year matters too: 2025 units carry the lowest median at $275, while 2021 tops the table at $277. Year-level pages linked in the table above break each one down by grade and variant.

Against comparable vehicles, the Kia K5 sits 46% above the Ram 1500 ($190), 21% above the Chevy Silverado 1500 ($228), and 14% above the GMC Sierra 1500 ($243) for the same part. The “similar vehicles” cards below open each comparison guide.

Buying a used drive shaft: what to check

  1. Flex universal joints and CV boots: Articulate each U-joint by hand to check for stiff binding, rusted needle bearings, or torn rubber constant-velocity boots.
  2. Inspect slip yoke splines and balance weights: Check male splines for twisting or galling, and verify that welded steel balance weights are present along the tube.
  3. Examine center carrier bearing rubber: Inspect two-piece driveshaft center bearings for cracked rubber mounting rings or noisy, dry support bearings.
  4. Measure overall compressed length: Verify flange-to-flange operating length exactly, as transmission options and wheelbase variations alter shaft dimensions.
  5. Index flange alignment before installation: Mark mating yokes to the differential flange before installation to prevent high-speed driveline vibration.

Keep browsing this vehicle

What other Kia K5 parts are priced?

Price comparisons

Compare Kia K5 drive shaft prices

Compare fitments

What do similar vehicles charge for this part?

Common questions

Kia K5 drive shaft FAQ

How much is a used drive shaft for a Kia K5?

The median asking price is $277 across 173 priced listings from 161 yards. Grade-A units, the cleanest stock, have a median of $257. 2025 is the cheapest model year we track, with a median of $275.

How much does it cost to replace a Kia K5 drive shaft?

Using a used part, a Kia K5 drive shaft replacement typically runs $370–$725 all-in: the median used drive shaft for this model lists at $277, and independent-shop labor for drive shaft replacement typically takes 1–3 hours at $95–$150/hr ($95–$450). Labor is a national part-level estimate, not a quote for your vehicle.

Which Kia K5 model years does this price guide cover?

This guide currently has year-level pricing for 2025, 2023, 2022, 2021. Other model years contribute to the overall range where sellers listed them without a year breakdown.

Which Kia K5 drive shaft years are interchangeable?

Salvage-yard interchange data links Kia K5 drive shaft fitments across 2021, 2022, 2023, 2024, 2025. Searching all 5 years widens the pool of units; confirm the part number against your VIN, since trim or drivetrain can split an interchange group.

Used Kia K5 Drive Shaft Cost — From $125 to $544