Used Kia Telluride drive shaft from a salvage yard

Vehicle-specific price guide

How much is a used Kia Telluride drive shaft?

Asking prices from 32 salvage yards in 6 states, broken down by model year, condition grade, and fitment variant.
SKWritten bySaurabh Kumar · Co-Founder & CTO
ASReviewed byAmbika Sharma · Co-Founder & COO
Last updatedSep 3, 2026
Strong coverage285 priced of 295 observed0 variantsMethodology v2.1 →

Part overview

About the Kia Telluride drive shaft

What the drive shaft does, common failure signs, and prices across all vehicles: used drive shaft price guide →

Also known asDriveshaftPropeller ShaftProp Shaft
Price summary

A used Kia Telluride drive shaft costs $90 to $550, with a median asking price of $229. Based on 285 priced salvage yard listings across the US, compatible across 2020–2025 (6 model years), updated Sep 3, 2026. Prices exclude shipping, core charges, and installation.

Grade A (excellent)$256
Grade B (good)$232

Kia Telluride drive shaft price snapshot

USD
Low
$90
Average
$217
High
$550
295 listings observed · 285 priced2mo ago· How we price·

Report incorrect price

Reporting price for Kia Telluride Drive Shaft

Reason

Condition comparison

Price by part grade

Grade AClean / low wear$98–$550144 listings
Grade BStandard used$100–$504133 listings
Grade XUngraded$90–$1008 listings

Median by grade

Grade price comparison

Median asking price by seller-reported condition grade · $90–$550 overall range

Regional supply

Where the Kia Telluride drive shaft is listed

We found priced Kia Telluride drive shaft listings at 32 salvage yards across 6 states. Illinois supplies the most, with 149 listings (52% of the total) from 6 yards. Location matters: yards in California ask a median $121, while Illinois yards ask $262, 117% more for the same part. Shipping usually costs less than that gap for smaller parts, so it can pay to buy out of state.

StateListingsYardsMedian ask
Illinois1496$262+14%
California7815$121-47%
Florida506$208-9%

States with at least 10 priced listings. % is versus the $229 national median.

Replacement cost

What is the Kia Telluride drive shaft replacement cost?

ESTIMATE
Used part
$229
Kia Telluride median asking price
Labor
$95–$450
1–3 hours at $95–$150/hr
Estimated total
$325–$680
median used part + labor

Labor is a typical independent-shop range for drive shaft replacement, not a quote for your vehicle. The part price is the live median from the salvage-yard listings on this page. Full drive shaft replacement cost breakdown

Sources
  1. Labor time estimates: Part Price Guide labor database

Set price alert

Alert for Kia Telluride Drive Shaft

$

Current avg: $217 — we suggest $184 (15% below)

Condition grade (optional)

Model-year comparison

What does a Kia Telluride drive shaft cost by year?

$109$151$193$234$276202020212022202320242025
Median asking price by model year · salvage yard listing data

Market analysis

How much does a used Kia Telluride drive shaft cost?

Asking prices for a used Kia Telluride drive shaft are unusually spread out: the top listing asks about 6 times what the cheapest does, so which unit you pick matters more than the median. Condition matters: grade-A units (lowest mileage, best condition) carry roughly a 10% premium over grade-B stock, with grade-A medians at $256.

Model year matters too: 2023 units carry the lowest median at $121, while 2021 tops the table at $263. Parts from 2020–2023 are interchangeable, so if the 2023 fits your vehicle, it offers the best value across 4 compatible years.

Against comparable vehicles, the Kia Telluride sits 21% above the Ram 1500 ($190), level with the Chevy Silverado 1500 ($228), and 6% below the GMC Sierra 1500 ($243) for the same part. The “similar vehicles” cards below open each comparison guide.

Buying a used drive shaft: what to check

  1. Flex universal joints and CV boots: Articulate each U-joint by hand to check for stiff binding, rusted needle bearings, or torn rubber constant-velocity boots.
  2. Inspect slip yoke splines and balance weights: Check male splines for twisting or galling, and verify that welded steel balance weights are present along the tube.
  3. Examine center carrier bearing rubber: Inspect two-piece driveshaft center bearings for cracked rubber mounting rings or noisy, dry support bearings.
  4. Measure overall compressed length: Verify flange-to-flange operating length exactly, as transmission options and wheelbase variations alter shaft dimensions.
  5. Index flange alignment before installation: Mark mating yokes to the differential flange before installation to prevent high-speed driveline vibration.

Keep browsing this vehicle

What other Kia Telluride parts are priced?

Price comparisons

Compare Kia Telluride drive shaft prices

Compare fitments

What do similar vehicles charge for this part?

Common questions

Kia Telluride drive shaft FAQ

How much is a used drive shaft for a Kia Telluride?

The median asking price is $229 across 285 priced listings from 32 yards. Grade-A units, the cleanest stock, have a median of $256. 2023 is the cheapest model year we track, with a median of $121.

How much does it cost to replace a Kia Telluride drive shaft?

Using a used part, a Kia Telluride drive shaft replacement typically runs $325–$680 all-in: the median used drive shaft for this model lists at $229, and independent-shop labor for drive shaft replacement typically takes 1–3 hours at $95–$150/hr ($95–$450). Labor is a national part-level estimate, not a quote for your vehicle.

Which Kia Telluride model years does this price guide cover?

This guide currently has year-level pricing for 2025, 2024, 2023, 2022, 2021, 2020, 2019. Other model years contribute to the overall range where sellers listed them without a year breakdown.

Which Kia Telluride drive shaft years are interchangeable?

Salvage-yard interchange data links Kia Telluride drive shaft fitments across 2020, 2021, 2022, 2023, 2024, 2025. Searching all 6 years widens the pool of units; confirm the part number against your VIN, since trim or drivetrain can split an interchange group.

Used Kia Telluride Drive Shaft Cost — From $90 to $550