GMC Acadia control arm price snapshot
- Low
- $50
- Average
- $136
- High
- $249

Vehicle-specific price guide
A used GMC Acadia control arm costs $50 to $249, with a median asking price of $145. Based on 91 priced salvage yard listings across the US, compatible across 2016–2020 (5 model years), updated Sep 12, 2026. Prices exclude shipping, core charges, and installation.
Condition comparison
| Grade | Price range | Relative range | Listings |
|---|---|---|---|
| Grade AClean / low wear | $50–$249 | 46 | |
| Grade BStandard used | $75–$249 | 37 | |
| Grade CVisible wear | $65–$65 | 4 | |
| Grade XUngraded | $75–$75 | 4 |
Median by grade
Median asking price by seller-reported condition grade · $50–$249 overall range
Replacement cost
Labor is a typical independent-shop range for control arm replacement, not a quote for your vehicle; it does not include a wheel alignment after installation. The part price is the live median from the salvage-yard listings on this page. Full control arm replacement cost breakdown
Fitment matters
Model-year comparison
Market analysis
The going rate for a used GMC Acadia control arm is $145 at the median, with listings spanning $50 to $249. That figure comes from 91 priced salvage-yard listings tracked by our index. Condition matters: grade-A units (lowest mileage, best condition) carry roughly a 123% premium over grade-C stock, with grade-A medians at $145.
Fitment variant moves the price more than most buyers expect. The most affordable variant we track, RH, lists at a $145 median, while LH commands $171, a 18% gap inside the same part category. Confirm which variant your VIN requires before comparing quotes.
Against comparable vehicles, the GMC Acadia sits 21% below the Toyota 4Runner ($183), 81% above the Ford Mustang ($80), and 45% above the Mercedes E Class ($100) for the same part. The “similar vehicles” cards below open each comparison guide.
Keep browsing this vehicle


























Price data updating







Price data updating






Price data updating















Price comparisons
Compare fitments
Common questions
Based on 91 priced salvage yard listings, a used GMC Acadia control arm lists between $50 and $249, with a median asking price of $145.
Using a used part, a GMC Acadia control arm replacement typically runs $240–$595 all-in: the median used control arm for this model lists at $145, and independent-shop labor for control arm replacement typically takes 1–3 hours at $95–$150/hr ($95–$450). The labor figure does not include a wheel alignment after installation. Labor is a national part-level estimate, not a quote for your vehicle.
Condition grade, mileage, model year, and fitment variant all move the price. Our data covers 2 distinct trims/variants for this part. Check the variant table above, since interchange differences can change the price substantially. Always confirm fitment against your VIN or part number before buying.
This guide currently has year-level pricing for 2023. Other model years contribute to the overall range where sellers listed them without a year breakdown.
Based on salvage-yard interchange data, GMC Acadia control arm listings appear across model years 2016, 2017, 2018, 2019, 2020, suggesting these years share compatible fitments. Shopping across all 5 years may surface better prices or grades. Always verify the exact part number and VIN before buying — interchange compatibility can vary by trim or drivetrain.
A lower control arm is another name for a control arm. The GMC Acadia control arm prices on this page apply — median $145, from 91 salvage yard listings.