Used Ram 2500 control arm from a salvage yard

Vehicle-specific price guide

How much is a used Ram 2500 control arm?

Asking prices from 252 salvage yards in 45 states, broken down by model year, condition grade, and fitment variant.
SKWritten bySaurabh Kumar · Co-Founder & CTO
ASReviewed byAmbika Sharma · Co-Founder & COO
Last updatedOct 21, 2026
Strong coverage2,078 priced of 2,945 observed6 variantsMethodology v2.1 →

Part overview

About the Ram 2500 control arm

What the control arm does, common failure signs, and prices across all vehicles: used control arm price guide →

Also known asLower Control ArmA-ArmWishbone
Price summary

A used Ram 2500 control arm costs $46 to $420, with a median asking price of $182. Based on 2,078 priced salvage yard listings across the US, compatible across 2013–2024 (12 model years), updated Oct 21, 2026. Prices exclude shipping, core charges, and installation.

Grade A (excellent)$154
Grade B (good)$203
Grade C (fair)$129

Ram 2500 control arm price snapshot

USD
Low
$46
Average
$181
High
$420
2,945 listings observed · 2,078 priced8d ago· How we price·

Report incorrect price

Reporting price for Ram 2500 Control Arm

Reason

Condition comparison

Price by part grade

Grade AClean / low wear$57–$400801 listings
Grade BStandard used$55–$4201,020 listings
Grade CVisible wear$75–$25086 listings
Grade XUngraded$46–$250171 listings

Median by grade

Grade price comparison

Median asking price by seller-reported condition grade · $46–$420 overall range

Regional supply

Where the Ram 2500 control arm is listed

We found priced Ram 2500 control arm listings at 252 salvage yards across 45 states. Texas supplies the most, with 322 listings (13% of the total) from 20 yards. Location matters: yards in California ask a median $150, while Kentucky yards ask $250, 67% more for the same part. Shipping usually costs less than that gap for smaller parts, so it can pay to buy out of state.

StateListingsYardsMedian ask
Texas32220$155-15%
California29920$150-18%
Arizona1998$154-15%
Missouri15214$175-4%
Michigan1299$190+4%
Wisconsin10012$150-18%
Kentucky915$250+37%
Nebraska858$171-6%

States with at least 10 priced listings. % is versus the $182 national median.

Replacement cost

What is the Ram 2500 control arm replacement cost?

ESTIMATE
Used part
$182
Ram 2500 median asking price
Labor
$95–$450
1–3 hours at $95–$150/hr
Estimated total
$275–$630
median used part + labor

Labor is a typical independent-shop range for control arm replacement, not a quote for your vehicle; it does not include a wheel alignment after installation. The part price is the live median from the salvage-yard listings on this page. Full control arm replacement cost breakdown

Sources
  1. Labor time estimates: Part Price Guide labor database

Set price alert

Alert for Ram 2500 Control Arm

$

Current avg: $181 — we suggest $154 (15% below)

Condition grade (optional)

Fitment matters

Price by trim & variant (2025)

4x2, RH36 listingsInterchange 2014–2024$105$57 – $262
4x2, LH35 listingsInterchange 2014–2024$113$57 – $275
4x4, opt SD1 (articulink suspension), RH35 listingsInterchange 2014–2023$225$111 – $400
4x4, w/o opt SD1; LH28 listingsInterchange 2013–2024$154$100 – $245
4x4, w/o opt SD1; RH28 listingsInterchange 2013–2024$144$93 – $334
4x4, opt SD1 (articulink suspension), LH25 listingsInterchange 2014–2024$277$86 – $400

Model-year comparison

What does a Ram 2500 control arm cost by year?

$158$177$197$217$23620152016201720182019202020212022202320242025
Median asking price by model year · salvage yard listing data

Market analysis

How much does a used Ram 2500 control arm cost?

Asking prices for a used Ram 2500 control arm are unusually spread out: the top listing asks about 9 times what the cheapest does, so which unit you pick matters more than the median. Condition matters: grade-A units (lowest mileage, best condition) carry roughly a 19% premium over grade-C stock, with grade-A medians at $154.

Fitment variant moves the price more than most buyers expect. The most affordable variant we track, 4x2, RH, lists at a $105 median, while 4x4, opt SD1 (articulink suspension), LH commands $277, a 164% gap inside the same part category. Confirm which variant your VIN requires before comparing quotes.

Model year matters too: 2015 units carry the lowest median at $175, while 2018 tops the table at $225. Parts from 2013–2024 are interchangeable, so if the 2015 fits your vehicle, it offers the best value across 12 compatible years.

Against comparable vehicles, the Ram 2500 sits 6% below the Toyota 4Runner ($193), 1% above the Mercedes S Class ($180), and 82% above the Mercedes E Class ($100) for the same part. The “similar vehicles” cards below open each comparison guide.

Buying a used control arm: what to check

  1. Inspect ball joint boot and stud play: Check for torn rubber dust boots, cracked grease seals, or lateral movement in the ball joint stud when flexed with a pry bar.
  2. Check rubber bushing integrity: Look for dry-rotted, torn, or fluid-leaking hydraulic suspension bushings where the arm mounts to the subframe.
  3. Verify structural straightness against factory specs: Compare the arm against original dimensions to spot subtle bends caused by curb strikes or suspension impacts.
  4. Confirm ball joint attachment design: Determine whether the arm uses a bolt-on ball joint or an integrated press-fit socket to anticipate future maintenance needs.
  5. Torque bushing bolts at ride height only: Tightening subframe pivot bolts while the vehicle is raised on jacks twists rubber bushings and causes premature tearing.

Keep browsing this vehicle

What other Ram 2500 parts are priced?

Price comparisons

Compare Ram 2500 control arm prices

Compare fitments

What do similar vehicles charge for this part?

Common questions

Ram 2500 control arm FAQ

How much is a used control arm for a Ram 2500?

The median asking price is $182 across 2,078 priced listings from 252 yards. Grade-A units, the cleanest stock, have a median of $154. 2025 is the cheapest model year we track, with a median of $175.

How much does it cost to replace a Ram 2500 control arm?

Using a used part, a Ram 2500 control arm replacement typically runs $275–$630 all-in: the median used control arm for this model lists at $182, and independent-shop labor for control arm replacement typically takes 1–3 hours at $95–$150/hr ($95–$450). The labor figure does not include a wheel alignment after installation. Labor is a national part-level estimate, not a quote for your vehicle.

Which Ram 2500 model years does this price guide cover?

This guide currently has year-level pricing for 2025, 2024, 2023, 2022, 2021, 2020, 2019, 2018, 2017, 2016, 2015. Other model years contribute to the overall range where sellers listed them without a year breakdown.

Which Ram 2500 control arm years are interchangeable?

Salvage-yard interchange data links Ram 2500 control arm fitments across 2013, 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2023, 2024. Searching all 12 years widens the pool of units; confirm the part number against your VIN, since trim or drivetrain can split an interchange group.

Used Ram 2500 Control Arm Cost — From $46 to $420