Used Ram 3500 control arm from a salvage yard

Vehicle-specific price guide

How much is a used Ram 3500 control arm?

Asking prices from 104 salvage yards in 28 states, broken down by model year, condition grade, and fitment variant.
SKWritten bySaurabh Kumar · Co-Founder & CTO
ASReviewed byAmbika Sharma · Co-Founder & COO
Last updatedOct 15, 2026
Strong coverage701 priced of 1,072 observed2 variantsMethodology v2.1 →

Part overview

About the Ram 3500 control arm

What the control arm does, common failure signs, and prices across all vehicles: used control arm price guide →

Also known asLower Control ArmA-ArmWishbone
Price summary

A used Ram 3500 control arm costs $93 to $387, with a median asking price of $187. Based on 701 priced salvage yard listings across the US, compatible across 2013–2026 (14 model years), updated Oct 15, 2026. Prices exclude shipping, core charges, and installation.

Grade A (excellent)$187
Grade B (good)$209
Grade C (fair)$150

Ram 3500 control arm price snapshot

USD
Low
$93
Average
$189
High
$387
1,072 listings observed · 701 priced14d ago· How we price·

Report incorrect price

Reporting price for Ram 3500 Control Arm

Reason

Condition comparison

Price by part grade

Grade AClean / low wear$93–$364229 listings
Grade BStandard used$94–$387391 listings
Grade CVisible wear$100–$21426 listings
Grade XUngraded$95–$20055 listings

Median by grade

Grade price comparison

Median asking price by seller-reported condition grade · $93–$387 overall range

Regional supply

Where the Ram 3500 control arm is listed

We found priced Ram 3500 control arm listings at 104 salvage yards across 28 states. Texas supplies the most, with 254 listings (33% of the total) from 13 yards. Location matters: yards in Missouri ask a median $150, while Florida yards ask $300, 100% more for the same part. Shipping usually costs less than that gap for smaller parts, so it can pay to buy out of state.

StateListingsYardsMedian ask
Texas25413$185-1%
Missouri1045$150-20%
Michigan645$220+18%
Indiana552$220+18%
California4511$210+12%
Arizona407$192+3%
Florida4012$300+60%
Kentucky324$257+37%

States with at least 10 priced listings. % is versus the $187 national median.

Replacement cost

What is the Ram 3500 control arm replacement cost?

ESTIMATE
Used part
$187
Ram 3500 median asking price
Labor
$95–$450
1–3 hours at $95–$150/hr
Estimated total
$280–$635
median used part + labor

Labor is a typical independent-shop range for control arm replacement, not a quote for your vehicle; it does not include a wheel alignment after installation. The part price is the live median from the salvage-yard listings on this page. Full control arm replacement cost breakdown

Sources
  1. Labor time estimates: Part Price Guide labor database

Set price alert

Alert for Ram 3500 Control Arm

$

Current avg: $189 — we suggest $161 (15% below)

Condition grade (optional)

Fitment matters

Price by trim & variant (2025)

LH47 listingsInterchange 2019–2024$220$100 – $297
RH46 listingsInterchange 2019–2024$220$100 – $315

Model-year comparison

What does a Ram 3500 control arm cost by year?

$138$171$204$237$27020152016201720182019202020212022202320242025
Median asking price by model year · salvage yard listing data

Market analysis

How much does a used Ram 3500 control arm cost?

Asking prices for a used Ram 3500 control arm are unusually spread out: the top listing asks about 4 times what the cheapest does, so which unit you pick matters more than the median. Condition matters: grade-A units (lowest mileage, best condition) carry roughly a 25% premium over grade-C stock, with grade-A medians at $187.

Model year matters too: 2016 units carry the lowest median at $153, while 2022 tops the table at $257. Parts from 2013–2024 are interchangeable, so if the 2016 fits your vehicle, it offers the best value across 12 compatible years.

Against comparable vehicles, the Ram 3500 sits 3% below the Toyota 4Runner ($193), 4% above the Mercedes S Class ($180), and 87% above the Mercedes E Class ($100) for the same part. The “similar vehicles” cards below open each comparison guide.

Buying a used control arm: what to check

  1. Inspect ball joint boot and stud play: Check for torn rubber dust boots, cracked grease seals, or lateral movement in the ball joint stud when flexed with a pry bar.
  2. Check rubber bushing integrity: Look for dry-rotted, torn, or fluid-leaking hydraulic suspension bushings where the arm mounts to the subframe.
  3. Verify structural straightness against factory specs: Compare the arm against original dimensions to spot subtle bends caused by curb strikes or suspension impacts.
  4. Confirm ball joint attachment design: Determine whether the arm uses a bolt-on ball joint or an integrated press-fit socket to anticipate future maintenance needs.
  5. Torque bushing bolts at ride height only: Tightening subframe pivot bolts while the vehicle is raised on jacks twists rubber bushings and causes premature tearing.

Keep browsing this vehicle

What other Ram 3500 parts are priced?

Price comparisons

Compare Ram 3500 control arm prices

Compare fitments

What do similar vehicles charge for this part?

Common questions

Ram 3500 control arm FAQ

How much is a used control arm for a Ram 3500?

The median asking price is $187 across 701 priced listings from 104 yards. Grade-A units, the cleanest stock, have a median of $187. 2017 is the cheapest model year we track, with a median of $153.

How much does it cost to replace a Ram 3500 control arm?

Using a used part, a Ram 3500 control arm replacement typically runs $280–$635 all-in: the median used control arm for this model lists at $187, and independent-shop labor for control arm replacement typically takes 1–3 hours at $95–$150/hr ($95–$450). The labor figure does not include a wheel alignment after installation. Labor is a national part-level estimate, not a quote for your vehicle.

Which Ram 3500 model years does this price guide cover?

This guide currently has year-level pricing for 2025, 2024, 2023, 2022, 2021, 2020, 2019, 2018, 2017, 2016, 2015. Other model years contribute to the overall range where sellers listed them without a year breakdown.

Which Ram 3500 control arm years are interchangeable?

Salvage-yard interchange data links Ram 3500 control arm fitments across 2013, 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2023, 2024, 2025, 2026. Searching all 14 years widens the pool of units; confirm the part number against your VIN, since trim or drivetrain can split an interchange group.

Used Ram 3500 Control Arm Cost — From $93 to $387