Used Ford Bronco drive shaft from a salvage yard

Vehicle-specific price guide

How much is a used Ford Bronco drive shaft?

Asking prices from 228 salvage yards in 38 states, broken down by model year, condition grade, and fitment variant.
SKWritten bySaurabh Kumar · Co-Founder & CTO
ASReviewed byAmbika Sharma · Co-Founder & COO
Last updatedOct 20, 2026
Strong coverage614 priced of 680 observed4 variantsMethodology v2.1 →

Part overview

About the Ford Bronco drive shaft

What the drive shaft does, common failure signs, and prices across all vehicles: used drive shaft price guide →

Also known asDriveshaftPropeller ShaftProp Shaft
Price summary

A used Ford Bronco drive shaft costs $132 to $681, with a median asking price of $330. Based on 614 priced salvage yard listings across the US, compatible across 2021–2025 (5 model years), updated Oct 20, 2026. Prices exclude shipping, core charges, and installation.

Grade A (excellent)$330
Grade B (good)$330

Ford Bronco drive shaft price snapshot

USD
Low
$132
Average
$330
High
$681
680 listings observed · 614 priced12d ago· How we price·

Report incorrect price

Reporting price for Ford Bronco Drive Shaft

Reason

Condition comparison

Price by part grade

Grade AClean / low wear$132–$681554 listings
Grade BStandard used$140–$55555 listings
Grade XUngraded$140–$3005 listings

Median by grade

Grade price comparison

Median asking price by seller-reported condition grade · $132–$681 overall range

Regional supply

Where the Ford Bronco drive shaft is listed

We found priced Ford Bronco drive shaft listings at 228 salvage yards across 38 states. Michigan supplies the most, with 127 listings (12% of the total) from 29 yards. Location matters: yards in Mississippi ask a median $250, while Florida yards ask $355, 42% more for the same part. Shipping usually costs less than that gap for smaller parts, so it can pay to buy out of state.

StateListingsYardsMedian ask
Michigan12729$270-18%
Florida11912$355+8%
Mississippi796$250-24%
Illinois789$288-13%
Ohio5512$257-22%
Tennessee506$330
Indiana498$268-19%
North Carolina4413$317-4%

States with at least 10 priced listings. % is versus the $330 national median.

Replacement cost

What is the Ford Bronco drive shaft replacement cost?

ESTIMATE
Used part
$330
Ford Bronco median asking price
Labor
$95–$450
1–3 hours at $95–$150/hr
Estimated total
$425–$780
median used part + labor

Labor is a typical independent-shop range for drive shaft replacement, not a quote for your vehicle. The part price is the live median from the salvage-yard listings on this page. Full drive shaft replacement cost breakdown

Sources
  1. Labor time estimates: Part Price Guide labor database

Set price alert

Alert for Ford Bronco Drive Shaft

$

Current avg: $330 — we suggest $281 (15% below)

Condition grade (optional)

Fitment matters

Price by trim & variant (2025)

Other years2024202320222021
full time 4x4, 4 Dr50 listingsInterchange 2021–2024$340$170 – $554
part time 4x4, 2 Dr47 listingsInterchange 2021–2024$337$170 – $673
part time 4x4, 4 Dr47 listingsInterchange 2021–2024$345$132 – $561
full time 4x4, 2 Dr35 listingsInterchange 2022–2023$365$145 – $681

Model-year comparison

What does a Ford Bronco drive shaft cost by year?

$245$279$314$349$38320212022202320242025
Median asking price by model year · salvage yard listing data

Market analysis

How much does a used Ford Bronco drive shaft cost?

Asking prices for a used Ford Bronco drive shaft are unusually spread out: the top listing asks about 5 times what the cheapest does, so which unit you pick matters more than the median.

Fitment variant moves the price more than most buyers expect. The most affordable variant we track, part time 4x4, 2 Dr, lists at a $337 median, while full time 4x4, 2 Dr commands $365, a 8% gap inside the same part category. Confirm which variant your VIN requires before comparing quotes.

Model year matters too: 2021 units carry the lowest median at $272, while 2022 tops the table at $365. Parts from 2021–2025 are interchangeable, so if the 2021 fits your vehicle, it offers the best value across 5 compatible years.

Against comparable vehicles, the Ford Bronco sits 74% above the Ram 1500 ($190), 45% above the Chevy Silverado 1500 ($228), and 36% above the GMC Sierra 1500 ($243) for the same part. The “similar vehicles” cards below open each comparison guide.

Buying a used drive shaft: what to check

  1. Flex universal joints and CV boots: Articulate each U-joint by hand to check for stiff binding, rusted needle bearings, or torn rubber constant-velocity boots.
  2. Inspect slip yoke splines and balance weights: Check male splines for twisting or galling, and verify that welded steel balance weights are present along the tube.
  3. Examine center carrier bearing rubber: Inspect two-piece driveshaft center bearings for cracked rubber mounting rings or noisy, dry support bearings.
  4. Measure overall compressed length: Verify flange-to-flange operating length exactly, as transmission options and wheelbase variations alter shaft dimensions.
  5. Index flange alignment before installation: Mark mating yokes to the differential flange before installation to prevent high-speed driveline vibration.

Keep browsing this vehicle

What other Ford Bronco parts are priced?

Price comparisons

Compare Ford Bronco drive shaft prices

Compare fitments

What do similar vehicles charge for this part?

Common questions

Ford Bronco drive shaft FAQ

How much is a used drive shaft for a Ford Bronco?

The median asking price is $330 across 614 priced listings from 228 yards. Grade-A units, the cleanest stock, have a median of $330. 2021 is the cheapest model year we track, with a median of $272.

How much does it cost to replace a Ford Bronco drive shaft?

Using a used part, a Ford Bronco drive shaft replacement typically runs $425–$780 all-in: the median used drive shaft for this model lists at $330, and independent-shop labor for drive shaft replacement typically takes 1–3 hours at $95–$150/hr ($95–$450). Labor is a national part-level estimate, not a quote for your vehicle.

Which Ford Bronco model years does this price guide cover?

This guide currently has year-level pricing for 2025, 2024, 2023, 2022, 2021. Other model years contribute to the overall range where sellers listed them without a year breakdown.

Which Ford Bronco drive shaft years are interchangeable?

Salvage-yard interchange data links Ford Bronco drive shaft fitments across 2021, 2022, 2023, 2024, 2025. Searching all 5 years widens the pool of units; confirm the part number against your VIN, since trim or drivetrain can split an interchange group.

Used Ford Bronco Drive Shaft Cost — From $132 to $681