Used Mercedes C Class drive shaft from a salvage yard

Vehicle-specific price guide

How much is a used Mercedes C Class drive shaft?

Asking prices from 453 salvage yards in 40 states, broken down by model year, condition grade, and fitment variant.
SKWritten bySaurabh Kumar · Co-Founder & CTO
ASReviewed byAmbika Sharma · Co-Founder & COO
Last updatedOct 22, 2026
Strong coverage1,846 priced of 2,143 observed2 variantsMethodology v2.1 →

Part overview

About the Mercedes C Class drive shaft

What the drive shaft does, common failure signs, and prices across all vehicles: used drive shaft price guide →

Also known asDriveshaftPropeller ShaftProp Shaft
Price summary

A used Mercedes C Class drive shaft costs $55 to $926, with a median asking price of $245. Based on 1,846 priced salvage yard listings across the US, compatible across 2008–2024 (17 model years), updated Oct 22, 2026. Prices exclude shipping, core charges, and installation.

Grade A (excellent)$250
Grade B (good)$193
Grade C (fair)$125

Mercedes C Class drive shaft price snapshot

USD
Low
$55
Average
$264
High
$926
2,143 listings observed · 1,846 priced10d ago· How we price·

Report incorrect price

Reporting price for Mercedes C Class Drive Shaft

Reason

Condition comparison

Price by part grade

Grade AClean / low wear$55–$9261,681 listings
Grade BStandard used$100–$30739 listings
Grade CVisible wear$125–$1251 listings
Grade XUngraded$60–$427125 listings

Median by grade

Grade price comparison

Median asking price by seller-reported condition grade · $55–$926 overall range

Regional supply

Where the Mercedes C Class drive shaft is listed

We found priced Mercedes C Class drive shaft listings at 453 salvage yards across 40 states. California supplies the most, with 248 listings (11% of the total) from 50 yards. Location matters: yards in New York ask a median $161, while Florida yards ask $383, 138% more for the same part. Shipping usually costs less than that gap for smaller parts, so it can pay to buy out of state.

StateListingsYardsMedian ask
California24850$193-21%
Texas20730$171-30%
Michigan18035$200-18%
Florida16426$383+56%
Illinois11222$248+1%
Wisconsin11212$233-5%
New York8929$161-34%
Indiana8916$250+2%

States with at least 10 priced listings. % is versus the $245 national median.

Replacement cost

What is the Mercedes C Class drive shaft replacement cost?

ESTIMATE
Used part
$245
Mercedes C Class median asking price
Labor
$95–$450
1–3 hours at $95–$150/hr
Estimated total
$340–$695
median used part + labor

Labor is a typical independent-shop range for drive shaft replacement, not a quote for your vehicle. The part price is the live median from the salvage-yard listings on this page. Full drive shaft replacement cost breakdown

Sources
  1. Labor time estimates: Part Price Guide labor database

Set price alert

Alert for Mercedes C Class Drive Shaft

$

Current avg: $264 — we suggest $224 (15% below)

Condition grade (optional)

Fitment matters

Price by trim & variant (2024)

Model-year comparison

What does a Mercedes C Class drive shaft cost by year?

$158$308$459$610$7602015201620172018201920202021202220232024
Median asking price by model year · salvage yard listing data

Market analysis

How much does a used Mercedes C Class drive shaft cost?

Asking prices for a used Mercedes C Class drive shaft are unusually spread out: the top listing asks more than ten times what the cheapest does, so which unit you pick matters more than the median. Condition matters: grade-A units (lowest mileage, best condition) carry roughly a 100% premium over grade-C stock, with grade-A medians at $250.

Fitment variant moves the price more than most buyers expect. The most affordable variant we track, Non-Interchange search using Mercedes C Class and similar models, lists at a $710 median, while Non-Interchange search using only Mercedes C Class commands $760, a 7% gap inside the same part category. Confirm which variant your VIN requires before comparing quotes.

Model year matters too: 2015 units carry the lowest median at $175, while 2024 tops the table at $724. Parts from 2008–2018 are interchangeable, so if the 2015 fits your vehicle, it offers the best value across 11 compatible years.

Against comparable vehicles, the Mercedes C Class sits 29% above the Ram 1500 ($190), 7% above the Chevy Silverado 1500 ($228), and 1% above the GMC Sierra 1500 ($243) for the same part. The “similar vehicles” cards below open each comparison guide.

Buying a used drive shaft: what to check

  1. Flex universal joints and CV boots: Articulate each U-joint by hand to check for stiff binding, rusted needle bearings, or torn rubber constant-velocity boots.
  2. Inspect slip yoke splines and balance weights: Check male splines for twisting or galling, and verify that welded steel balance weights are present along the tube.
  3. Examine center carrier bearing rubber: Inspect two-piece driveshaft center bearings for cracked rubber mounting rings or noisy, dry support bearings.
  4. Measure overall compressed length: Verify flange-to-flange operating length exactly, as transmission options and wheelbase variations alter shaft dimensions.
  5. Index flange alignment before installation: Mark mating yokes to the differential flange before installation to prevent high-speed driveline vibration.

Keep browsing this vehicle

What other Mercedes C Class parts are priced?

Price comparisons

Compare Mercedes C Class drive shaft prices

Compare fitments

What do similar vehicles charge for this part?

Common questions

Mercedes C Class drive shaft FAQ

How much is a used drive shaft for a Mercedes C Class?

The median asking price is $245 across 1,846 priced listings from 453 yards. Grade-A units, the cleanest stock, have a median of $250. 2015 is the cheapest model year we track, with a median of $175.

How much does it cost to replace a Mercedes C Class drive shaft?

Using a used part, a Mercedes C Class drive shaft replacement typically runs $340–$695 all-in: the median used drive shaft for this model lists at $245, and independent-shop labor for drive shaft replacement typically takes 1–3 hours at $95–$150/hr ($95–$450). Labor is a national part-level estimate, not a quote for your vehicle.

Which Mercedes C Class model years does this price guide cover?

This guide currently has year-level pricing for 2024, 2023, 2022, 2021, 2020, 2019, 2018, 2017, 2016, 2015. Other model years contribute to the overall range where sellers listed them without a year breakdown.

Which Mercedes C Class drive shaft years are interchangeable?

Salvage-yard interchange data links Mercedes C Class drive shaft fitments across 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2023, 2024. Searching all 17 years widens the pool of units; confirm the part number against your VIN, since trim or drivetrain can split an interchange group.

Used Mercedes C Class Drive Shaft Cost — From $55 to $926