Used Mercedes S Class drive shaft from a salvage yard

Vehicle-specific price guide

How much is a used Mercedes S Class drive shaft?

Asking prices from 196 salvage yards in 35 states, broken down by model year, condition grade, and fitment variant.
SKWritten bySaurabh Kumar · Co-Founder & CTO
ASReviewed byAmbika Sharma · Co-Founder & COO
Last updatedOct 9, 2026
Strong coverage1,176 priced of 1,386 observed2 variantsMethodology v2.1 →

Part overview

About the Mercedes S Class drive shaft

What the drive shaft does, common failure signs, and prices across all vehicles: used drive shaft price guide →

Also known asDriveshaftPropeller ShaftProp Shaft
Price summary

A used Mercedes S Class drive shaft costs $108 to $962, with a median asking price of $342. Based on 1,176 priced salvage yard listings across the US, compatible across 2013–2024 (12 model years), updated Oct 9, 2026. Prices exclude shipping, core charges, and installation.

Grade A (excellent)$345
Grade B (good)$318

Mercedes S Class drive shaft price snapshot

USD
Low
$108
Average
$364
High
$962
1,386 listings observed · 1,176 priced20d ago· How we price·

Report incorrect price

Reporting price for Mercedes S Class Drive Shaft

Reason

Condition comparison

Price by part grade

Grade AClean / low wear$108–$9621,050 listings
Grade BStandard used$150–$83881 listings
Grade XUngraded$125–$64945 listings

Median by grade

Grade price comparison

Median asking price by seller-reported condition grade · $108–$962 overall range

Regional supply

Where the Mercedes S Class drive shaft is listed

We found priced Mercedes S Class drive shaft listings at 196 salvage yards across 35 states. Michigan supplies the most, with 182 listings (15% of the total) from 15 yards. Location matters: yards in California ask a median $200, while Indiana yards ask $482, 141% more for the same part. Shipping usually costs less than that gap for smaller parts, so it can pay to buy out of state.

StateListingsYardsMedian ask
Michigan18215$317-7%
California15826$200-42%
Missouri1207$401+17%
Indiana913$482+41%
North Carolina7411$358+5%
Florida669$387+13%
South Carolina615$358+5%
New Jersey528$443+30%

States with at least 10 priced listings. % is versus the $342 national median.

Replacement cost

What is the Mercedes S Class drive shaft replacement cost?

ESTIMATE
Used part
$342
Mercedes S Class median asking price
Labor
$95–$450
1–3 hours at $95–$150/hr
Estimated total
$435–$790
median used part + labor

Labor is a typical independent-shop range for drive shaft replacement, not a quote for your vehicle. The part price is the live median from the salvage-yard listings on this page. Full drive shaft replacement cost breakdown

Sources
  1. Labor time estimates: Part Price Guide labor database

Set price alert

Alert for Mercedes S Class Drive Shaft

$

Current avg: $364 — we suggest $309 (15% below)

Condition grade (optional)

Fitment matters

Price by trim & variant (2024)

Model-year comparison

What does a Mercedes S Class drive shaft cost by year?

$270$374$478$583$6872015201620172018201920202021202220232024
Median asking price by model year · salvage yard listing data

Market analysis

How much does a used Mercedes S Class drive shaft cost?

Asking prices for a used Mercedes S Class drive shaft are unusually spread out: the top listing asks about 9 times what the cheapest does, so which unit you pick matters more than the median. Condition matters: grade-A units (lowest mileage, best condition) carry roughly a 8% premium over grade-B stock, with grade-A medians at $345.

Model year matters too: 2015 units carry the lowest median at $300, while 2022 tops the table at $654. Parts from 2013–2017 are interchangeable, so if the 2015 fits your vehicle, it offers the best value across 5 compatible years.

Against comparable vehicles, the Mercedes S Class sits 80% above the Ram 1500 ($190), 50% above the Chevy Silverado 1500 ($228), and 41% above the GMC Sierra 1500 ($243) for the same part. The “similar vehicles” cards below open each comparison guide.

Buying a used drive shaft: what to check

  1. Flex universal joints and CV boots: Articulate each U-joint by hand to check for stiff binding, rusted needle bearings, or torn rubber constant-velocity boots.
  2. Inspect slip yoke splines and balance weights: Check male splines for twisting or galling, and verify that welded steel balance weights are present along the tube.
  3. Examine center carrier bearing rubber: Inspect two-piece driveshaft center bearings for cracked rubber mounting rings or noisy, dry support bearings.
  4. Measure overall compressed length: Verify flange-to-flange operating length exactly, as transmission options and wheelbase variations alter shaft dimensions.
  5. Index flange alignment before installation: Mark mating yokes to the differential flange before installation to prevent high-speed driveline vibration.

Keep browsing this vehicle

What other Mercedes S Class parts are priced?

Price comparisons

Compare Mercedes S Class drive shaft prices

Compare fitments

What do similar vehicles charge for this part?

Common questions

Mercedes S Class drive shaft FAQ

How much is a used drive shaft for a Mercedes S Class?

The median asking price is $342 across 1,176 priced listings from 196 yards. Grade-A units, the cleanest stock, have a median of $345. 2015 is the cheapest model year we track, with a median of $300.

How much does it cost to replace a Mercedes S Class drive shaft?

Using a used part, a Mercedes S Class drive shaft replacement typically runs $435–$790 all-in: the median used drive shaft for this model lists at $342, and independent-shop labor for drive shaft replacement typically takes 1–3 hours at $95–$150/hr ($95–$450). Labor is a national part-level estimate, not a quote for your vehicle.

Which Mercedes S Class model years does this price guide cover?

This guide currently has year-level pricing for 2024, 2023, 2022, 2021, 2020, 2019, 2018, 2017, 2016, 2015. Other model years contribute to the overall range where sellers listed them without a year breakdown.

Which Mercedes S Class drive shaft years are interchangeable?

Salvage-yard interchange data links Mercedes S Class drive shaft fitments across 2013, 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2023, 2024. Searching all 12 years widens the pool of units; confirm the part number against your VIN, since trim or drivetrain can split an interchange group.

Used Mercedes S Class Drive Shaft Cost — From $108 to $962