Used Nissan Murano torque converter from a salvage yard

Vehicle-specific price guide

How much is a used Nissan Murano torque converter?

Asking prices from 2 salvage yards in 2 states, broken down by model year, condition grade, and fitment variant.
SKWritten bySaurabh Kumar · Co-Founder & CTO
ASReviewed byAmbika Sharma · Co-Founder & COO
Last updatedSep 21, 2026
Limited coverage4 priced of 22 observed2 variantsMethodology v2.1 →

Part overview

About the Nissan Murano torque converter

What the torque converter does, common failure signs, and prices across all vehicles: used torque converter price guide →

Also known asTransmission Torque ConverterTorque Convertor

Request price data

Requesting data for Nissan Murano torque converter

We'll notify you when the data is live. No spam.

Price summary

A used Nissan Murano torque converter costs $270 to $499, with a median asking price of $499. Based on 4 priced salvage yard listings across the US, compatible across 2016–2025 (7 model years), updated Sep 21, 2026. Prices exclude shipping, core charges, and installation.

Grade A (excellent)$499
Grade B (good)$270

Nissan Murano torque converter price snapshot

USD
Low
$270
Average
$385
High
$499
22 listings observed · 4 priced1mo ago· How we price·

Report incorrect price

Reporting price for Nissan Murano Torque Converter

Reason

Condition comparison

Price by part grade

Grade AClean / low wear$499–$4992 listings
Grade BStandard used$270–$2702 listings

Median by grade

Grade price comparison

Median asking price by seller-reported condition grade · $270–$499 overall range

Replacement cost

What is the Nissan Murano torque converter replacement cost?

ESTIMATE
Used part
$499
Nissan Murano median asking price
Labor
$475–$1,500
5–10 hours at $95–$150/hr
Estimated total
$975–$2,000
median used part + labor

Labor is a typical independent-shop range for torque converter replacement, not a quote for your vehicle; it does not include transmission fluid and filter, since the transmission must be removed to access the converter. The part price is the live median from the salvage-yard listings on this page. Full torque converter replacement cost breakdown

Sources
  1. Labor time estimates: Part Price Guide labor database

Set price alert

Alert for Nissan Murano Torque Converter

$

Current avg: $385 — we suggest $327 (15% below)

Condition grade (optional)

Fitment matters

Price by trim & variant (2025)

Non-Interchange search using Nissan Murano and similar models

1 listings
$499$499 – $499

Non-Interchange search using only Nissan Murano

1 listings
$499$499 – $499

Model-year comparison

What does a Nissan Murano torque converter cost by year?

Market analysis

How much does a used Nissan Murano torque converter cost?

Asking prices for a used Nissan Murano torque converter sit in a fairly tight band around the $499 median, so most quotes far outside it deserve a second look. Condition matters: grade-A units (lowest mileage, best condition) carry roughly a 85% premium over grade-B stock, with grade-A medians at $499.

Model year matters too: 2023 units carry the lowest median at $270, while 2025 tops the table at $499. Year-level pages linked in the table above break each one down by grade and variant.

Against comparable vehicles, the Nissan Murano sits 128% above the Jeep Compass ($219), 132% above the Jeep Cherokee ($215), and 105% above the Volkswagen Atlas ($244) for the same part. The “similar vehicles” cards below open each comparison guide.

Buying a used torque converter: what to check

  1. Inspect hub neck snout and drive notch: Check the small transmission pump drive neck for deep grooves, burrs, or rounded drive blade notches.
  2. Verify internal stator one-way clutch operation: Insert a spline tool into the stator hub to confirm it locks firmly in one direction and spins freely in the other.
  3. Check starter ring gear tooth condition: Examine outer perimeter ring gear teeth for chipped, rounded, or ground-down teeth caused by starter engagement failures.
  4. Confirm pilot hub diameter and bolt pattern: Measure pilot stub diameter and bolt circle spacing to match your engine crankshaft and flexplate layout.
  5. Fully seat converter splines before transmission bolting: Spin and push the converter until it drops past two distinct spline steps into the oil pump drive.

Keep browsing this vehicle

What other Nissan Murano parts are priced?

Compare fitments

What do similar vehicles charge for this part?

Common questions

Nissan Murano torque converter FAQ

How much is a used torque converter for a Nissan Murano?

The median asking price is $499 across 4 priced listings from 2 yards. Grade-A units, the cleanest stock, have a median of $499. 2023 is the cheapest model year we track, with a median of $270.

How much does it cost to replace a Nissan Murano torque converter?

Using a used part, a Nissan Murano torque converter replacement typically runs $975–$2,000 all-in: the median used torque converter for this model lists at $499, and independent-shop labor for torque converter replacement typically takes 5–10 hours at $95–$150/hr ($475–$1,500). The labor figure does not include transmission fluid and filter, since the transmission must be removed to access the converter. Labor is a national part-level estimate, not a quote for your vehicle.

Which Nissan Murano model years does this price guide cover?

This guide currently has year-level pricing for 2025, 2023, 2021, 2020, 2019, 2018, 2017, 2016. Other model years contribute to the overall range where sellers listed them without a year breakdown.

Which Nissan Murano torque converter years are interchangeable?

Salvage-yard interchange data links Nissan Murano torque converter fitments across 2016, 2017, 2019, 2020, 2021, 2023, 2025. Searching all 7 years widens the pool of units; confirm the part number against your VIN, since trim or drivetrain can split an interchange group.

Used Nissan Murano Torque Converter Cost — From $270 to $499