Used Mazda 3 control arm from a salvage yard

Vehicle-specific price guide

How much is a used Mazda 3 control arm?

Asking prices from 212 salvage yards in 40 states, broken down by model year, condition grade, and fitment variant.
SKWritten bySaurabh Kumar · Co-Founder & CTO
ASReviewed byAmbika Sharma · Co-Founder & COO
Last updatedOct 21, 2026
Strong coverage744 priced of 970 observed2 variantsMethodology v2.1 →

Part overview

About the Mazda 3 control arm

What the control arm does, common failure signs, and prices across all vehicles: used control arm price guide →

Also known asLower Control ArmA-ArmWishbone
Price summary

A used Mazda 3 control arm costs $34 to $343, with a median asking price of $100. Based on 744 priced salvage yard listings across the US, compatible across 2014–2025 (12 model years), updated Oct 21, 2026. Prices exclude shipping, core charges, and installation.

Grade A (excellent)$100
Grade B (good)$96

Mazda 3 control arm price snapshot

USD
Low
$34
Average
$122
High
$343
970 listings observed · 744 priced11d ago· How we price·

Report incorrect price

Reporting price for Mazda 3 Control Arm

Reason

Condition comparison

Price by part grade

Grade AClean / low wear$34–$343567 listings
Grade BStandard used$46–$280119 listings
Grade XUngraded$46–$14658 listings

Median by grade

Grade price comparison

Median asking price by seller-reported condition grade · $34–$343 overall range

Regional supply

Where the Mazda 3 control arm is listed

We found priced Mazda 3 control arm listings at 212 salvage yards across 40 states. California supplies the most, with 277 listings (37% of the total) from 39 yards. Location matters: yards in California ask a median $75, while Nebraska yards ask $199, 165% more for the same part. Shipping usually costs less than that gap for smaller parts, so it can pay to buy out of state.

StateListingsYardsMedian ask
California27739$75-25%
Arizona4012$75-25%
Utah329$75-25%
Ohio299$144+44%
Michigan2610$193+93%
Colorado203$124+24%
Nebraska205$199+99%
Pennsylvania198$143+43%

States with at least 10 priced listings. % is versus the $100 national median.

Replacement cost

What is the Mazda 3 control arm replacement cost?

ESTIMATE
Used part
$100
Mazda 3 median asking price
Labor
$95–$450
1–3 hours at $95–$150/hr
Estimated total
$195–$550
median used part + labor

Labor is a typical independent-shop range for control arm replacement, not a quote for your vehicle; it does not include a wheel alignment after installation. The part price is the live median from the salvage-yard listings on this page. Full control arm replacement cost breakdown

Sources
  1. Labor time estimates: Part Price Guide labor database

Set price alert

Alert for Mazda 3 Control Arm

$

Current avg: $122 — we suggest $104 (15% below)

Condition grade (optional)

Fitment matters

Price by trim & variant (2025)

Model-year comparison

What does a Mazda 3 control arm cost by year?

$59$100$142$183$22520152016201720182019202020212022202320242025
Median asking price by model year · salvage yard listing data

Market analysis

How much does a used Mazda 3 control arm cost?

Asking prices for a used Mazda 3 control arm are unusually spread out: the top listing asks more than ten times what the cheapest does, so which unit you pick matters more than the median. Condition matters: grade-A units (lowest mileage, best condition) carry roughly a 4% premium over grade-B stock, with grade-A medians at $100.

Model year matters too: 2015 units carry the lowest median at $65, while 2024 tops the table at $214. Parts from 2014–2016 are interchangeable, so if the 2015 fits your vehicle, it offers the best value across 3 compatible years.

Against comparable vehicles, the Mazda 3 sits 48% below the Toyota 4Runner ($193), 44% below the Mercedes S Class ($180), and level with the Mercedes E Class ($100) for the same part. The “similar vehicles” cards below open each comparison guide.

Buying a used control arm: what to check

  1. Inspect ball joint boot and stud play: Check for torn rubber dust boots, cracked grease seals, or lateral movement in the ball joint stud when flexed with a pry bar.
  2. Check rubber bushing integrity: Look for dry-rotted, torn, or fluid-leaking hydraulic suspension bushings where the arm mounts to the subframe.
  3. Verify structural straightness against factory specs: Compare the arm against original dimensions to spot subtle bends caused by curb strikes or suspension impacts.
  4. Confirm ball joint attachment design: Determine whether the arm uses a bolt-on ball joint or an integrated press-fit socket to anticipate future maintenance needs.
  5. Torque bushing bolts at ride height only: Tightening subframe pivot bolts while the vehicle is raised on jacks twists rubber bushings and causes premature tearing.

Keep browsing this vehicle

What other Mazda 3 parts are priced?

Price comparisons

Compare Mazda 3 control arm prices

Compare fitments

What do similar vehicles charge for this part?

Common questions

Mazda 3 control arm FAQ

How much is a used control arm for a Mazda 3?

The median asking price is $100 across 744 priced listings from 212 yards. Grade-A units, the cleanest stock, have a median of $100. 2015 is the cheapest model year we track, with a median of $65.

How much does it cost to replace a Mazda 3 control arm?

Using a used part, a Mazda 3 control arm replacement typically runs $195–$550 all-in: the median used control arm for this model lists at $100, and independent-shop labor for control arm replacement typically takes 1–3 hours at $95–$150/hr ($95–$450). The labor figure does not include a wheel alignment after installation. Labor is a national part-level estimate, not a quote for your vehicle.

Which Mazda 3 model years does this price guide cover?

This guide currently has year-level pricing for 2025, 2024, 2023, 2022, 2021, 2020, 2019, 2018, 2017, 2016, 2015. Other model years contribute to the overall range where sellers listed them without a year breakdown.

Which Mazda 3 control arm years are interchangeable?

Salvage-yard interchange data links Mazda 3 control arm fitments across 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2023, 2024, 2025. Searching all 12 years widens the pool of units; confirm the part number against your VIN, since trim or drivetrain can split an interchange group.

Used Mazda 3 Control Arm Cost — From $34 to $343