Chevy Colorado drive shaft price snapshot
- Low
- $2
- Average
- $773
- High
- $35,210

Vehicle-specific price guide
A used Chevy Colorado drive shaft costs $2 to $35,210, with a median asking price of $200. Based on 3,523 priced salvage yard listings across the US, compatible across 2014–2026 (13 model years), updated Sep 12, 2026. Prices exclude shipping, core charges, and installation.
Condition comparison
| Grade | Price range | Relative range | Listings |
|---|---|---|---|
| Grade AClean / low wear | $50–$30,320 | 2,566 | |
| Grade BStandard used | $75–$35,210 | 708 | |
| Grade CVisible wear | $91–$160 | 11 | |
| Grade XUngraded | $2–$500 | 238 |
Median by grade
Median asking price by seller-reported condition grade · $2–$35,210 overall range
Replacement cost
Labor is a typical independent-shop range for drive shaft replacement, not a quote for your vehicle. The part price is the live median from the salvage-yard listings on this page. Full drive shaft replacement cost breakdown
Model-year comparison
Market analysis
The going rate for a used Chevy Colorado drive shaft is $200 at the median, with listings spanning $2 to $35,210. That figure comes from 3,523 priced salvage-yard listings tracked by our index. Condition matters: grade-A units (lowest mileage, best condition) carry roughly a 58% premium over grade-C stock, with grade-A medians at $208.
Fitment variant moves the price more than most buyers expect. The most affordable variant we track, 4x4, lists at a $215 median, while 4x2 commands $223, a 4% gap inside the same part category. Confirm which variant your VIN requires before comparing quotes.
Model year matters too: 2017 units carry the lowest median at $131, while 2022 tops the table at $240. Parts from 2014–2019 are interchangeable, so if the 2017 fits your vehicle, it offers the best value across 5 compatible years.
Against comparable vehicles, the Chevy Colorado sits 19% below the GMC Sierra 1500 ($248), 5% above the Ram 1500 ($190), and 18% below the Ford F150 ($243) for the same part. The “similar vehicles” cards below open each comparison guide.
Keep browsing this vehicle


























Price data updating













Price data updating















Price comparisons
Compare fitments
Price data updating
Common questions
Based on 3,523 priced salvage yard listings, a used Chevy Colorado drive shaft lists between $2 and $35,210, with a median asking price of $200.
Using a used part, a Chevy Colorado drive shaft replacement typically runs $295–$650 all-in: the median used drive shaft for this model lists at $200, and independent-shop labor for drive shaft replacement typically takes 1–3 hours at $95–$150/hr ($95–$450). Labor is a national part-level estimate, not a quote for your vehicle.
Condition grade, mileage, model year, and fitment variant all move the price. Our data covers 2 distinct trims/variants for this part. Check the variant table above, since interchange differences can change the price substantially. Always confirm fitment against your VIN or part number before buying.
This guide currently has year-level pricing for 2025, 2024, 2023, 2022, 2021, 2020, 2019, 2018, 2017, 2015. Other model years contribute to the overall range where sellers listed them without a year breakdown.
Based on salvage-yard interchange data, Chevy Colorado drive shaft listings appear across model years 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2023, 2024, 2025, 2026, suggesting these years share compatible fitments. Shopping across all 13 years may surface better prices or grades. Always verify the exact part number and VIN before buying — interchange compatibility can vary by trim or drivetrain.
A driveshaft is another name for a drive shaft. The Chevy Colorado drive shaft prices on this page apply — median $200, from 3,523 salvage yard listings.