Used Chevy Trax drive shaft from a salvage yard

Vehicle-specific price guide

How much is a used Chevy Trax drive shaft?

Asking prices from 41 salvage yards in 7 states, broken down by model year, condition grade, and fitment variant.
SKWritten bySaurabh Kumar · Co-Founder & CTO
ASReviewed byAmbika Sharma · Co-Founder & COO
Last updatedSep 20, 2026
Strong coverage331 priced of 412 observed0 variantsMethodology v2.1 →

Part overview

About the Chevy Trax drive shaft

What the drive shaft does, common failure signs, and prices across all vehicles: used drive shaft price guide →

Also known asDriveshaftPropeller ShaftProp Shaft
Price summary

A used Chevy Trax drive shaft costs $65 to $410, with a median asking price of $132. Based on 331 priced salvage yard listings across the US, compatible across 2013–2025 (12 model years), updated Sep 20, 2026. Prices exclude shipping, core charges, and installation.

Grade A (excellent)$132
Grade B (good)$190
Grade C (fair)$100

Chevy Trax drive shaft price snapshot

USD
Low
$65
Average
$164
High
$410
412 listings observed · 331 priced1mo ago· How we price·

Report incorrect price

Reporting price for Chevy Trax Drive Shaft

Reason

Condition comparison

Price by part grade

Grade AClean / low wear$70–$410255 listings
Grade BStandard used$65–$41065 listings
Grade CVisible wear$75–$1002 listings
Grade XUngraded$75–$1259 listings

Median by grade

Grade price comparison

Median asking price by seller-reported condition grade · $65–$410 overall range

Regional supply

Where the Chevy Trax drive shaft is listed

We found priced Chevy Trax drive shaft listings at 41 salvage yards across 7 states. Texas supplies the most, with 152 listings (46% of the total) from 10 yards. Location matters: yards in Arizona ask a median $96, while Nevada yards ask $316, 229% more for the same part. Shipping usually costs less than that gap for smaller parts, so it can pay to buy out of state.

StateListingsYardsMedian ask
Texas15210$186+41%
Florida8612$125-5%
Arizona286$96-27%
Indiana272$180+36%
Illinois238$125-5%
Nevada142$316+139%

States with at least 10 priced listings. % is versus the $132 national median.

Replacement cost

What is the Chevy Trax drive shaft replacement cost?

ESTIMATE
Used part
$132
Chevy Trax median asking price
Labor
$95–$450
1–3 hours at $95–$150/hr
Estimated total
$225–$580
median used part + labor

Labor is a typical independent-shop range for drive shaft replacement, not a quote for your vehicle. The part price is the live median from the salvage-yard listings on this page. Full drive shaft replacement cost breakdown

Sources
  1. Labor time estimates: Part Price Guide labor database

Set price alert

Alert for Chevy Trax Drive Shaft

$

Current avg: $164 — we suggest $139 (15% below)

Condition grade (optional)

Model-year comparison

What does a Chevy Trax drive shaft cost by year?

$104$126$149$172$19520152016201720182019202020212022
Median asking price by model year · salvage yard listing data

Market analysis

How much does a used Chevy Trax drive shaft cost?

Asking prices for a used Chevy Trax drive shaft are unusually spread out: the top listing asks about 6 times what the cheapest does, so which unit you pick matters more than the median. Condition matters: grade-A units (lowest mileage, best condition) carry roughly a 32% premium over grade-C stock, with grade-A medians at $132.

Model year matters too: 2018 units carry the lowest median at $115, while 2016 tops the table at $186. Parts from 2015–2022 are interchangeable, so if the 2018 fits your vehicle, it offers the best value across 8 compatible years.

Against comparable vehicles, the Chevy Trax sits 31% below the Ram 1500 ($190), 42% below the Chevy Silverado 1500 ($228), and 46% below the GMC Sierra 1500 ($243) for the same part. The “similar vehicles” cards below open each comparison guide.

Buying a used drive shaft: what to check

  1. Flex universal joints and CV boots: Articulate each U-joint by hand to check for stiff binding, rusted needle bearings, or torn rubber constant-velocity boots.
  2. Inspect slip yoke splines and balance weights: Check male splines for twisting or galling, and verify that welded steel balance weights are present along the tube.
  3. Examine center carrier bearing rubber: Inspect two-piece driveshaft center bearings for cracked rubber mounting rings or noisy, dry support bearings.
  4. Measure overall compressed length: Verify flange-to-flange operating length exactly, as transmission options and wheelbase variations alter shaft dimensions.
  5. Index flange alignment before installation: Mark mating yokes to the differential flange before installation to prevent high-speed driveline vibration.

Keep browsing this vehicle

What other Chevy Trax parts are priced?

Price comparisons

Compare Chevy Trax drive shaft prices

Compare fitments

What do similar vehicles charge for this part?

Common questions

Chevy Trax drive shaft FAQ

How much is a used drive shaft for a Chevy Trax?

The median asking price is $132 across 331 priced listings from 41 yards. Grade-A units, the cleanest stock, have a median of $132. 2018 is the cheapest model year we track, with a median of $115.

How much does it cost to replace a Chevy Trax drive shaft?

Using a used part, a Chevy Trax drive shaft replacement typically runs $225–$580 all-in: the median used drive shaft for this model lists at $132, and independent-shop labor for drive shaft replacement typically takes 1–3 hours at $95–$150/hr ($95–$450). Labor is a national part-level estimate, not a quote for your vehicle.

Which Chevy Trax model years does this price guide cover?

This guide currently has year-level pricing for 2025, 2024, 2022, 2021, 2020, 2019, 2018, 2017, 2016, 2015. Other model years contribute to the overall range where sellers listed them without a year breakdown.

Which Chevy Trax drive shaft years are interchangeable?

Salvage-yard interchange data links Chevy Trax drive shaft fitments across 2013, 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2024, 2025. Searching all 12 years widens the pool of units; confirm the part number against your VIN, since trim or drivetrain can split an interchange group.

Used Chevy Trax Drive Shaft Cost — From $65 to $410