Used Chevy Traverse drive shaft from a salvage yard

Vehicle-specific price guide

How much is a used Chevy Traverse drive shaft?

Asking prices from 58 salvage yards in 7 states, broken down by model year, condition grade, and fitment variant.
SKWritten bySaurabh Kumar · Co-Founder & CTO
ASReviewed byAmbika Sharma · Co-Founder & COO
Last updatedSep 20, 2026
Strong coverage446 priced of 534 observed0 variantsMethodology v2.1 →

Part overview

About the Chevy Traverse drive shaft

What the drive shaft does, common failure signs, and prices across all vehicles: used drive shaft price guide →

Also known asDriveshaftPropeller ShaftProp Shaft
Price summary

A used Chevy Traverse drive shaft costs $50 to $387, with a median asking price of $126. Based on 446 priced salvage yard listings across the US, compatible across 2012–2024 (13 model years), updated Sep 20, 2026. Prices exclude shipping, core charges, and installation.

Grade A (excellent)$126
Grade B (good)$126
Grade C (fair)$200

Chevy Traverse drive shaft price snapshot

USD
Low
$50
Average
$162
High
$387
534 listings observed · 446 priced1mo ago· How we price·

Report incorrect price

Reporting price for Chevy Traverse Drive Shaft

Reason

Condition comparison

Price by part grade

Grade AClean / low wear$50–$329235 listings
Grade BStandard used$58–$387196 listings
Grade CVisible wear$75–$2002 listings
Grade XUngraded$75–$25013 listings

Median by grade

Grade price comparison

Median asking price by seller-reported condition grade · $50–$387 overall range

Regional supply

Where the Chevy Traverse drive shaft is listed

We found priced Chevy Traverse drive shaft listings at 58 salvage yards across 7 states. Texas supplies the most, with 209 listings (47% of the total) from 16 yards. Location matters: yards in Illinois ask a median $85, while Arizona yards ask $218, 156% more for the same part. Shipping usually costs less than that gap for smaller parts, so it can pay to buy out of state.

StateListingsYardsMedian ask
Texas20916$126
California11319$100-21%
Arizona404$218+73%
Nevada386$164+30%
Illinois338$85-33%
New Mexico103$95-25%

States with at least 10 priced listings. % is versus the $126 national median.

Replacement cost

What is the Chevy Traverse drive shaft replacement cost?

ESTIMATE
Used part
$126
Chevy Traverse median asking price
Labor
$95–$450
1–3 hours at $95–$150/hr
Estimated total
$220–$575
median used part + labor

Labor is a typical independent-shop range for drive shaft replacement, not a quote for your vehicle. The part price is the live median from the salvage-yard listings on this page. Full drive shaft replacement cost breakdown

Sources
  1. Labor time estimates: Part Price Guide labor database

Set price alert

Alert for Chevy Traverse Drive Shaft

$

Current avg: $162 — we suggest $138 (15% below)

Condition grade (optional)

Model-year comparison

What does a Chevy Traverse drive shaft cost by year?

$77$108$140$171$20320152016201720182019202020212022202320242025
Median asking price by model year · salvage yard listing data

Market analysis

How much does a used Chevy Traverse drive shaft cost?

Asking prices for a used Chevy Traverse drive shaft are unusually spread out: the top listing asks about 8 times what the cheapest does, so which unit you pick matters more than the median.

Model year matters too: 2017 units carry the lowest median at $85, while 2015 tops the table at $193. Parts from 2012–2017 are interchangeable, so if the 2017 fits your vehicle, it offers the best value across 6 compatible years.

Against comparable vehicles, the Chevy Traverse sits 34% below the Ram 1500 ($190), 45% below the Chevy Silverado 1500 ($228), and 48% below the GMC Sierra 1500 ($243) for the same part. The “similar vehicles” cards below open each comparison guide.

Buying a used drive shaft: what to check

  1. Flex universal joints and CV boots: Articulate each U-joint by hand to check for stiff binding, rusted needle bearings, or torn rubber constant-velocity boots.
  2. Inspect slip yoke splines and balance weights: Check male splines for twisting or galling, and verify that welded steel balance weights are present along the tube.
  3. Examine center carrier bearing rubber: Inspect two-piece driveshaft center bearings for cracked rubber mounting rings or noisy, dry support bearings.
  4. Measure overall compressed length: Verify flange-to-flange operating length exactly, as transmission options and wheelbase variations alter shaft dimensions.
  5. Index flange alignment before installation: Mark mating yokes to the differential flange before installation to prevent high-speed driveline vibration.

Keep browsing this vehicle

What other Chevy Traverse parts are priced?

Price comparisons

Compare Chevy Traverse drive shaft prices

Compare fitments

What do similar vehicles charge for this part?

Common questions

Chevy Traverse drive shaft FAQ

How much is a used drive shaft for a Chevy Traverse?

The median asking price is $126 across 446 priced listings from 58 yards. Grade-A units, the cleanest stock, have a median of $126. 2017 is the cheapest model year we track, with a median of $85.

How much does it cost to replace a Chevy Traverse drive shaft?

Using a used part, a Chevy Traverse drive shaft replacement typically runs $220–$575 all-in: the median used drive shaft for this model lists at $126, and independent-shop labor for drive shaft replacement typically takes 1–3 hours at $95–$150/hr ($95–$450). Labor is a national part-level estimate, not a quote for your vehicle.

Which Chevy Traverse model years does this price guide cover?

This guide currently has year-level pricing for 2025, 2024, 2023, 2022, 2021, 2020, 2019, 2018, 2017, 2016, 2015. Other model years contribute to the overall range where sellers listed them without a year breakdown.

Which Chevy Traverse drive shaft years are interchangeable?

Salvage-yard interchange data links Chevy Traverse drive shaft fitments across 2012, 2013, 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2023, 2024. Searching all 13 years widens the pool of units; confirm the part number against your VIN, since trim or drivetrain can split an interchange group.

Used Chevy Traverse Drive Shaft Cost — From $50 to $387