Used Chevy Impala drive shaft from a salvage yard

Vehicle-specific price guide

How much is a used Chevy Impala drive shaft?

Asking prices from 17 salvage yards in 11 states, broken down by model year, condition grade, and fitment variant.
SKWritten bySaurabh Kumar · Co-Founder & CTO
ASReviewed byAmbika Sharma · Co-Founder & COO
Last updatedOct 27, 2026
Limited coverage18 priced of 64 observed1 variantMethodology v2.1 →

Part overview

About the Chevy Impala drive shaft

What the drive shaft does, common failure signs, and prices across all vehicles: used drive shaft price guide →

Also known asDriveshaftPropeller ShaftProp Shaft
Price summary

A used Chevy Impala drive shaft costs $60 to $450, with a median asking price of $260. Based on 18 priced salvage yard listings across the US, compatible across 2015–2020 (4 model years), updated Oct 27, 2026. Prices exclude shipping, core charges, and installation.

Grade A (excellent)$260

Chevy Impala drive shaft price snapshot

USD
Low
$60
Average
$260
High
$450
64 listings observed · 18 pricedUpdated 1d ago· How we price·

Report incorrect price

Reporting price for Chevy Impala Drive Shaft

Reason

Condition comparison

Price by part grade

Grade AClean / low wear$60–$45018 listings

Replacement cost

What is the Chevy Impala drive shaft replacement cost?

ESTIMATE
Used part
$260
Chevy Impala median asking price
Labor
$95–$450
1–3 hours at $95–$150/hr
Estimated total
$355–$710
median used part + labor

Labor is a typical independent-shop range for drive shaft replacement, not a quote for your vehicle. The part price is the live median from the salvage-yard listings on this page. Full drive shaft replacement cost breakdown

Sources
  1. Labor time estimates: Part Price Guide labor database

Set price alert

Alert for Chevy Impala Drive Shaft

$

Current avg: $260 — we suggest $221 (15% below)

Condition grade (optional)

Fitment matters

Price by trim & variant (2016)

Other years202020182015

Model-year comparison

What does a Chevy Impala drive shaft cost by year?

Market analysis

How much does a used Chevy Impala drive shaft cost?

Asking prices for a used Chevy Impala drive shaft are unusually spread out: the top listing asks about 8 times what the cheapest does, so which unit you pick matters more than the median.

Model year matters too: 2016 units carry the lowest median at $100, while 2015 tops the table at $260. Year-level pages linked in the table above break each one down by grade and variant.

Against comparable vehicles, the Chevy Impala sits 37% above the Ram 1500 ($190), 14% above the Chevy Silverado 1500 ($228), and 7% above the GMC Sierra 1500 ($243) for the same part. The “similar vehicles” cards below open each comparison guide.

Buying a used drive shaft: what to check

  1. Flex universal joints and CV boots: Articulate each U-joint by hand to check for stiff binding, rusted needle bearings, or torn rubber constant-velocity boots.
  2. Inspect slip yoke splines and balance weights: Check male splines for twisting or galling, and verify that welded steel balance weights are present along the tube.
  3. Examine center carrier bearing rubber: Inspect two-piece driveshaft center bearings for cracked rubber mounting rings or noisy, dry support bearings.
  4. Measure overall compressed length: Verify flange-to-flange operating length exactly, as transmission options and wheelbase variations alter shaft dimensions.
  5. Index flange alignment before installation: Mark mating yokes to the differential flange before installation to prevent high-speed driveline vibration.

Keep browsing this vehicle

What other Chevy Impala parts are priced?

Price comparisons

Compare Chevy Impala drive shaft prices

Compare fitments

What do similar vehicles charge for this part?

Common questions

Chevy Impala drive shaft FAQ

How much is a used drive shaft for a Chevy Impala?

The median asking price is $260 across 18 priced listings from 17 yards. Grade-A units, the cleanest stock, have a median of $260. 2016 is the cheapest model year we track, with a median of $100.

How much does it cost to replace a Chevy Impala drive shaft?

Using a used part, a Chevy Impala drive shaft replacement typically runs $355–$710 all-in: the median used drive shaft for this model lists at $260, and independent-shop labor for drive shaft replacement typically takes 1–3 hours at $95–$150/hr ($95–$450). Labor is a national part-level estimate, not a quote for your vehicle.

Which Chevy Impala model years does this price guide cover?

This guide currently has year-level pricing for 2020, 2018, 2016, 2015. Other model years contribute to the overall range where sellers listed them without a year breakdown.

Which Chevy Impala drive shaft years are interchangeable?

Salvage-yard interchange data links Chevy Impala drive shaft fitments across 2015, 2016, 2018, 2020. Searching all 4 years widens the pool of units; confirm the part number against your VIN, since trim or drivetrain can split an interchange group.

Used Chevy Impala Drive Shaft Cost — From $60 to $450