Used Jeep Cherokee drive shaft from a salvage yard

Vehicle-specific price guide

How much is a used Jeep Cherokee drive shaft?

Asking prices from 58 salvage yards in 15 states, broken down by model year, condition grade, and fitment variant.
SKWritten bySaurabh Kumar · Co-Founder & CTO
ASReviewed byAmbika Sharma · Co-Founder & COO
Last updatedOct 22, 2026
Strong coverage396 priced of 430 observed0 variantsMethodology v2.1 →

Part overview

About the Jeep Cherokee drive shaft

What the drive shaft does, common failure signs, and prices across all vehicles: used drive shaft price guide →

Also known asDriveshaftPropeller ShaftProp Shaft
Price summary

A used Jeep Cherokee drive shaft costs $50 to $322, with a median asking price of $172. Based on 396 priced salvage yard listings across the US, compatible across 2014–2022 (9 model years), updated Oct 22, 2026. Prices exclude shipping, core charges, and installation.

Grade A (excellent)$175
Grade B (good)$170
Grade C (fair)$90

Jeep Cherokee drive shaft price snapshot

USD
Low
$50
Average
$168
High
$322
430 listings observed · 396 priced9d ago· How we price·

Report incorrect price

Reporting price for Jeep Cherokee Drive Shaft

Reason

Condition comparison

Price by part grade

Grade AClean / low wear$50–$322282 listings
Grade BStandard used$61–$308106 listings
Grade CVisible wear$90–$901 listings
Grade XUngraded$106–$1507 listings

Median by grade

Grade price comparison

Median asking price by seller-reported condition grade · $50–$322 overall range

Regional supply

Where the Jeep Cherokee drive shaft is listed

We found priced Jeep Cherokee drive shaft listings at 58 salvage yards across 15 states. Illinois supplies the most, with 186 listings (25% of the total) from 5 yards. Location matters: yards in Georgia ask a median $94, while Connecticut yards ask $215, 129% more for the same part. Shipping usually costs less than that gap for smaller parts, so it can pay to buy out of state.

StateListingsYardsMedian ask
Illinois1865$175+2%
California14616$155-10%
Wisconsin682$200+16%
Georgia601$94-45%
Arizona4511$119-31%
Alaska383$150-13%
Pennsylvania362$125-27%
Connecticut343$215+25%

States with at least 10 priced listings. % is versus the $172 national median.

Replacement cost

What is the Jeep Cherokee drive shaft replacement cost?

ESTIMATE
Used part
$172
Jeep Cherokee median asking price
Labor
$95–$450
1–3 hours at $95–$150/hr
Estimated total
$265–$620
median used part + labor

Labor is a typical independent-shop range for drive shaft replacement, not a quote for your vehicle. The part price is the live median from the salvage-yard listings on this page. Full drive shaft replacement cost breakdown

Sources
  1. Labor time estimates: Part Price Guide labor database

Set price alert

Alert for Jeep Cherokee Drive Shaft

$

Current avg: $168 — we suggest $143 (15% below)

Condition grade (optional)

Model-year comparison

What does a Jeep Cherokee drive shaft cost by year?

$95$131$166$202$237201520162017201820192020202120222023
Median asking price by model year · salvage yard listing data

Market analysis

How much does a used Jeep Cherokee drive shaft cost?

Asking prices for a used Jeep Cherokee drive shaft are unusually spread out: the top listing asks about 6 times what the cheapest does, so which unit you pick matters more than the median. Condition matters: grade-A units (lowest mileage, best condition) carry roughly a 94% premium over grade-C stock, with grade-A medians at $175.

Model year matters too: 2020 units carry the lowest median at $106, while 2016 tops the table at $226. Parts from 2014–2021 are interchangeable, so if the 2020 fits your vehicle, it offers the best value across 8 compatible years.

Against comparable vehicles, the Jeep Cherokee sits 9% below the Ram 1500 ($190), 25% below the Chevy Silverado 1500 ($228), and 29% below the GMC Sierra 1500 ($243) for the same part. The “similar vehicles” cards below open each comparison guide.

Buying a used drive shaft: what to check

  1. Flex universal joints and CV boots: Articulate each U-joint by hand to check for stiff binding, rusted needle bearings, or torn rubber constant-velocity boots.
  2. Inspect slip yoke splines and balance weights: Check male splines for twisting or galling, and verify that welded steel balance weights are present along the tube.
  3. Examine center carrier bearing rubber: Inspect two-piece driveshaft center bearings for cracked rubber mounting rings or noisy, dry support bearings.
  4. Measure overall compressed length: Verify flange-to-flange operating length exactly, as transmission options and wheelbase variations alter shaft dimensions.
  5. Index flange alignment before installation: Mark mating yokes to the differential flange before installation to prevent high-speed driveline vibration.

Keep browsing this vehicle

What other Jeep Cherokee parts are priced?

Price comparisons

Compare Jeep Cherokee drive shaft prices

Compare fitments

What do similar vehicles charge for this part?

Common questions

Jeep Cherokee drive shaft FAQ

How much is a used drive shaft for a Jeep Cherokee?

The median asking price is $172 across 396 priced listings from 58 yards. Grade-A units, the cleanest stock, have a median of $175. 2020 is the cheapest model year we track, with a median of $106.

How much does it cost to replace a Jeep Cherokee drive shaft?

Using a used part, a Jeep Cherokee drive shaft replacement typically runs $265–$620 all-in: the median used drive shaft for this model lists at $172, and independent-shop labor for drive shaft replacement typically takes 1–3 hours at $95–$150/hr ($95–$450). Labor is a national part-level estimate, not a quote for your vehicle.

Which Jeep Cherokee model years does this price guide cover?

This guide currently has year-level pricing for 2023, 2022, 2021, 2020, 2019, 2018, 2017, 2016, 2015. Other model years contribute to the overall range where sellers listed them without a year breakdown.

Which Jeep Cherokee drive shaft years are interchangeable?

Salvage-yard interchange data links Jeep Cherokee drive shaft fitments across 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022. Searching all 9 years widens the pool of units; confirm the part number against your VIN, since trim or drivetrain can split an interchange group.

Used Jeep Cherokee Drive Shaft Cost — From $50 to $322