Jeep Gladiator drive shaft price snapshot
- Low
- $155
- Average
- $270
- High
- $375

Vehicle-specific price guide
A used Jeep Gladiator drive shaft costs $155 to $375, with a median asking price of $247. Based on 19 priced salvage yard listings across the US, compatible across 2020–2024 (5 model years), updated Sep 13, 2026. Prices exclude shipping, core charges, and installation.
Condition comparison
| Grade | Price range | Relative range | Listings |
|---|---|---|---|
| Grade AClean / low wear | $155–$374 | 15 | |
| Grade BStandard used | $170–$375 | 4 | |
| Grade CVisible wear | Updating | — | |
| Grade XUngraded | Updating | — |
Median by grade
Median asking price by seller-reported condition grade · $155–$375 overall range
Replacement cost
Labor is a typical independent-shop range for drive shaft replacement, not a quote for your vehicle. The part price is the live median from the salvage-yard listings on this page. Full drive shaft replacement cost breakdown
Fitment matters
Model-year comparison
Market analysis
The going rate for a used Jeep Gladiator drive shaft is $247 at the median, with listings spanning $155 to $375. That figure comes from 19 priced salvage-yard listings tracked by our index.
Fitment variant moves the price more than most buyers expect. The most affordable variant we track, 4.10 ratio (differential), lists at a $247 median, while 3.73 ratio (differential) commands $366, a 48% gap inside the same part category. Confirm which variant your VIN requires before comparing quotes.
Against comparable vehicles, the Jeep Gladiator sits level with the GMC Sierra 1500 ($248), 30% above the Ram 1500 ($190), and 2% above the Ford F150 ($243) for the same part. The “similar vehicles” cards below open each comparison guide.
Keep browsing this vehicle


Price data updating










Price data updating


Price data updating












Price data updating













Price data updating

Price data updating














Price comparisons
Compare fitments
Common questions
Based on 19 priced salvage yard listings, a used Jeep Gladiator drive shaft lists between $155 and $375, with a median asking price of $247.
Using a used part, a Jeep Gladiator drive shaft replacement typically runs $340–$695 all-in: the median used drive shaft for this model lists at $247, and independent-shop labor for drive shaft replacement typically takes 1–3 hours at $95–$150/hr ($95–$450). Labor is a national part-level estimate, not a quote for your vehicle.
Condition grade, mileage, model year, and fitment variant all move the price. Our data covers 2 distinct trims/variants for this part. Check the variant table above, since interchange differences can change the price substantially. Always confirm fitment against your VIN or part number before buying.
This guide currently has year-level pricing for 2020. Other model years contribute to the overall range where sellers listed them without a year breakdown.
Based on salvage-yard interchange data, Jeep Gladiator drive shaft listings appear across model years 2020, 2021, 2022, 2023, 2024, suggesting these years share compatible fitments. Shopping across all 5 years may surface better prices or grades. Always verify the exact part number and VIN before buying — interchange compatibility can vary by trim or drivetrain.
A driveshaft is another name for a drive shaft. The Jeep Gladiator drive shaft prices on this page apply — median $247, from 19 salvage yard listings.