Used Jeep Wrangler drive shaft from a salvage yard

Vehicle-specific price guide

How much is a used Jeep Wrangler drive shaft?

Asking prices from 522 salvage yards in 48 states, broken down by model year, condition grade, and fitment variant.
SKWritten bySaurabh Kumar · Co-Founder & CTO
ASReviewed byAmbika Sharma · Co-Founder & COO
Last updatedOct 22, 2026
Strong coverage4,494 priced of 4,865 observed13 variantsMethodology v2.1 →

Part overview

About the Jeep Wrangler drive shaft

What the drive shaft does, common failure signs, and prices across all vehicles: used drive shaft price guide →

Also known asDriveshaftPropeller ShaftProp Shaft
Price summary

A used Jeep Wrangler drive shaft costs $63 to $690, with a median asking price of $230. Based on 4,494 priced salvage yard listings across the US, compatible across 2007–2025 (19 model years), updated Oct 22, 2026. Prices exclude shipping, core charges, and installation.

Grade A (excellent)$230
Grade B (good)$238
Grade C (fair)$150

Jeep Wrangler drive shaft price snapshot

USD
Low
$63
Average
$235
High
$690
4,865 listings observed · 4,494 priced11d ago· How we price·

Report incorrect price

Reporting price for Jeep Wrangler Drive Shaft

Reason

Condition comparison

Price by part grade

Grade AClean / low wear$63–$6903,839 listings
Grade BStandard used$76–$447379 listings
Grade CVisible wear$100–$1674 listings
Grade XUngraded$65–$395272 listings

Median by grade

Grade price comparison

Median asking price by seller-reported condition grade · $63–$690 overall range

Regional supply

Where the Jeep Wrangler drive shaft is listed

We found priced Jeep Wrangler drive shaft listings at 522 salvage yards across 48 states. California supplies the most, with 1,260 listings (23% of the total) from 46 yards. Location matters: yards in Indiana ask a median $158, while Florida yards ask $309, 96% more for the same part. Shipping usually costs less than that gap for smaller parts, so it can pay to buy out of state.

StateListingsYardsMedian ask
California1,26046$236+3%
Illinois72727$230
Texas53835$208-10%
Indiana45918$158-31%
Michigan42246$230
Ohio23724$240+4%
Florida22528$309+34%
Wisconsin18914$262+14%

States with at least 10 priced listings. % is versus the $230 national median.

Replacement cost

What is the Jeep Wrangler drive shaft replacement cost?

ESTIMATE
Used part
$230
Jeep Wrangler median asking price
Labor
$95–$450
1–3 hours at $95–$150/hr
Estimated total
$325–$680
median used part + labor

Labor is a typical independent-shop range for drive shaft replacement, not a quote for your vehicle. The part price is the live median from the salvage-yard listings on this page. Full drive shaft replacement cost breakdown

Sources
  1. Labor time estimates: Part Price Guide labor database

Set price alert

Alert for Jeep Wrangler Drive Shaft

$

Current avg: $235 — we suggest $200 (15% below)

Condition grade (optional)

Fitment matters

Price by trim & variant (2025)

4 Dr, 220mm, 2.0L, gasoline, Sport33 listingsInterchange 2018–2024$201$100 – $350
4 Dr, 200mm26 listingsInterchange 2018–2025$197$85 – $350
4 Dr, 220mm, 3.6L, Sport15 listingsInterchange 2018–2024$218$125 – $350
4 Dr, 220mm, 6.4L (wide)15 listingsInterchange 2021–2024$268$145 – $505
2 Dr, 220mm, w/o wide track13 listingsInterchange 2018–2023$255$126 – $418
4 Dr, 220mm, 2.0L, hybrid (wide), 3.73 ratio12 listingsInterchange 2021–2022$312$170 – $330
2 Dr, 200mm11 listingsInterchange 2018–2022$213$119 – $366
2 Dr, 220mm, wide track11 listingsInterchange 2018–2021$365$154 – $412
4 Dr, 220mm, 2.0L, gasoline, Rubicon (wide)11 listingsInterchange 2018–2025$250$100 – $375
4 Dr, 220mm, 3.6L, Rubicon (wide)11 listingsInterchange 2018–2025$250$100 – $375
4 Dr, 220mm, 2.0L, hybrid (wide), 4.10 ratio10 listingsInterchange 2021–2025$272$190 – $354
4 Dr, 220mm, 2.0L, gasoline, Sahara9 listingsInterchange 2018–2024$166$125 – $312
4 Dr, 220mm, 3.6L, Sahara9 listingsInterchange 2018–2024$166$125 – $312

Model-year comparison

What does a Jeep Wrangler drive shaft cost by year?

$175$199$223$248$27220152016201720182019202020212022202320242025
Median asking price by model year · salvage yard listing data

Market analysis

How much does a used Jeep Wrangler drive shaft cost?

Asking prices for a used Jeep Wrangler drive shaft are unusually spread out: the top listing asks more than ten times what the cheapest does, so which unit you pick matters more than the median. Condition matters: grade-A units (lowest mileage, best condition) carry roughly a 53% premium over grade-C stock, with grade-A medians at $230.

Fitment variant moves the price more than most buyers expect. The most affordable variant we track, 4 Dr, 220mm, 2.0L, gasoline, Sahara, lists at a $166 median, while 2 Dr, 220mm, wide track commands $365, a 120% gap inside the same part category. Confirm which variant your VIN requires before comparing quotes.

Model year matters too: 2017 units carry the lowest median at $194, while 2022 tops the table at $259. Parts from 2010–2018 are interchangeable, so if the 2017 fits your vehicle, it offers the best value across 9 compatible years.

Against comparable vehicles, the Jeep Wrangler sits 21% above the Ram 1500 ($190), 1% above the Chevy Silverado 1500 ($228), and 5% below the GMC Sierra 1500 ($243) for the same part. The “similar vehicles” cards below open each comparison guide.

Buying a used drive shaft: what to check

  1. Flex universal joints and CV boots: Articulate each U-joint by hand to check for stiff binding, rusted needle bearings, or torn rubber constant-velocity boots.
  2. Inspect slip yoke splines and balance weights: Check male splines for twisting or galling, and verify that welded steel balance weights are present along the tube.
  3. Examine center carrier bearing rubber: Inspect two-piece driveshaft center bearings for cracked rubber mounting rings or noisy, dry support bearings.
  4. Measure overall compressed length: Verify flange-to-flange operating length exactly, as transmission options and wheelbase variations alter shaft dimensions.
  5. Index flange alignment before installation: Mark mating yokes to the differential flange before installation to prevent high-speed driveline vibration.

Keep browsing this vehicle

What other Jeep Wrangler parts are priced?

Price comparisons

Compare Jeep Wrangler drive shaft prices

Compare fitments

What do similar vehicles charge for this part?

Common questions

Jeep Wrangler drive shaft FAQ

How much is a used drive shaft for a Jeep Wrangler?

The median asking price is $230 across 4,494 priced listings from 522 yards. Grade-A units, the cleanest stock, have a median of $230. 2017 is the cheapest model year we track, with a median of $194.

How much does it cost to replace a Jeep Wrangler drive shaft?

Using a used part, a Jeep Wrangler drive shaft replacement typically runs $325–$680 all-in: the median used drive shaft for this model lists at $230, and independent-shop labor for drive shaft replacement typically takes 1–3 hours at $95–$150/hr ($95–$450). Labor is a national part-level estimate, not a quote for your vehicle.

Which Jeep Wrangler model years does this price guide cover?

This guide currently has year-level pricing for 2025, 2024, 2023, 2022, 2021, 2020, 2019, 2018, 2017, 2016, 2015. Other model years contribute to the overall range where sellers listed them without a year breakdown.

Which Jeep Wrangler drive shaft years are interchangeable?

Salvage-yard interchange data links Jeep Wrangler drive shaft fitments across 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2023, 2024, 2025. Searching all 19 years widens the pool of units; confirm the part number against your VIN, since trim or drivetrain can split an interchange group.

Used Jeep Wrangler Drive Shaft Cost — From $63 to $690